Industrial Lock & Hardware allone Quick Start Manual

BEEPS S UMMARY
1 beep: Keypress
2 beeps: User code entered
2 beeps (after 3 seconds): Programming mode entered
2 asc ending beeps: Unloc king suc cessful
2 descending beeps: Loc king suc cessful
3 varied beeps: New c ode entered
4 quick beeps: Incorrect code entered
4 quick, descending beeps: Low battery
Elec tronic Door Loc k
Quic k S tart G uide
TO INS TALL THE LOC K
1. Remove the existing lock.
2. Position the exterior lock assembly (with keypad) on the outside of the door, en-
suring the plunger assembly is positioned at the edge of the door as shown (1).
3. Using the 2 #8-32 x 3/8" flat head screws provided, install the door edge cover on
the edge of the door. Ensure the door edge cover is flush to the edge of the door.
4. C onnect the cable attached to the interior lock housing to the cable attached to
the exterior lock housing. Position the cable inside the door as shown (2) to avoid
pinching and binding.
5. Position the interior lock assembly on the door, ensuring:
The deadbolt post is inserted in the red deadbolt lever so that the lever
•
operates the deadbolt.
• The interior handle post is positioned on the door edge side of the latch
tab so that the handle operates the latch.
The 3 screw posts on the interior housing align with the 3 screw bosses
•
on the exterior housing. Do not overtighten the screws.
6. S ecure the lock housings with the 4 #8-32 x 7/8" oval head screws provided.
7. Ensure the handle operates the latch and the red deadbolt lever operates the
deadbolt.
8. C heck that the strike plate is properly aligned with the lock. The plunger should
extend fully into the strike plate when the door is locked.
BATTERY COMES INCLUDED
Uses one C123 or 123A or 123 Lithium Battery
Industrial Lock & Hardware Inc.
40222 La Quinta Ln B101
Palmdale Ca 93551
(661) 224-1010 ph
www.ch751.com