Table of Contents
Advertisement
Quick Links
1
Important safety information
WARNING: Failure to follow these safety instructions could result in fire, electric
shock, or other injury or damage to the AttackPRO Camera or other property.
After reading this document carefully, keep it in a safe place for later reference.
Intended Use:
Model FA-BAA Battery pack is intended for use only with the Seek Thermal,
Model FQ-PPAX, AttackPRO - Thermal Imaging Camera.
Charging:
• This battery is intended to be charged only with the following equipment:
• The battery should only be charged indoors. Do not charge the product
outside or in the rain
• NEVER recharge the battery in a potentially explosive environment
• If the battery does not become fully charged after 4 hours, disconnect the
unit from the charger
• Do not attempt to disassemble the product. Any attempt to open the
welded housing will void the warranty. The battery does not contain any
user serviceable components. Should your unit need service, contact Seek
Thermal technical support at
NOTICE:
• As with most electronic products, this equipment must be disposed of in an
environmentally friendly way and in accordance with existing regulations for
electronic waste
• Do not alter or cover over any labels on the battery
• Batteries should be placed in a location that is average room temperature
(73˚F/ 23˚C), protected from weather, water, chemicals, and direct long term
sunlight exposure
• Clean the battery contacts and also those of the equipment prior to battery
installation
1 (5)
AttackPRO battery user manual
– Seek Thermal AttackPRO Camera Model FQ-PPAX
– Charger Model FD-PAA
– Desktop Charger Model FD-SAA
www.thermal.com/support
www.thermal.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Seek Thermal AttackPRO
Summary of Contents for Seek Thermal AttackPRO
- Page 1 Important safety information WARNING: Failure to follow these safety instructions could result in fire, electric shock, or other injury or damage to the AttackPRO Camera or other property. After reading this document carefully, keep it in a safe place for later reference.
- Page 2 Discontinue use immediately and promptly and properly dispose of unit • When disconnected from the AttackPRO camera, do not expose the battery to any liquids • Always keep the battery out of reach of infants, small children or pets •...
- Page 3 Cleaning and care The Seek AttackPRO battery requires little maintenance. For best care, please follow the guidelines below: • Gently use a cotton swap damped with isopropyl alcohol to wipe the contacts if they appear dirty or covered with debris www.thermal.com...
- Page 4 RED flashing indicator when battery inserted. Ensure AC power source is adequate & safe. Ensure battery contacts are clean. Battery will not charge. Clean battery charging contacts. Warranty information Please refer to the warranty documentation included in the AttackPRO imager (camera) product for further warranty coverage and information. Seek Thermal www.thermal.com www.thermal.com/support www.thermal.com...
- Page 5 ROHS: This RoHS-compliant product conforms to the European Union Restriction of the Use of Certain Hazardous Substances (RoHS) in Electrical and Electronic Equipment. Seek Thermal ensures RoHS conformance by requiring supplier Declarations of Conformity, monitoring incoming materials, and maintaining manufacturing process controls.
Need help?
Do you have a question about the AttackPRO and is the answer not in the manual?
Questions and answers