Puls UZS24.100 Installation Manual

EN UZS24.100 Installation Manual
DE UZS24.100 Installationsanleitung
FR UZS24.100 Manuel d'installation
ES UZS24.100 Manual de instalación
Doc. ID: PU-393.015.20-xxA (2019-01-10-MR1)

Product Description

This sensor board contains a PT1000 temperature sensor and an auto-resettable
fuse, which is suitable for charging currents up to 3.5A. The fuse protects the center-
tap wire between the battery module and the DC-UPS control unit. This sensor board
is compatible with most of the UB20 and UB40 control units and enables all the
benefits of the 1-Battery-Concept. This sensor board makes the use of matched
replacement batteries unnecessary and allows a precise battery charging and testing
which results in the longest possible battery life.

Intended Use

This sensor board is designed for 24V, 20A DC-UPS battery modules. The use of this
sensor board is optional.
If this device is used in a manner outside of its specification, the protection provided
by the device may be impaired.

Installation Instructions

The sensor board shall be installed as close as possible to the batteries in order to measure the precise temperature of the batteries.
A Connect pin 11 and 12 (Temp. Sensor) to the corresponding pins on the DC-UPS control unit.
B Connect pin 13 (Tap) to the corresponding pin on the DC-UPS control unit. Using the center tap connection is optional. Without this connection,
the DC-UPS will function like a traditional UPS system without the above mentioned benefits.
C Connect the blue wire (AWG18, length 0.5m) to the interconnection between the two batteries. Shorten the wire to the required length. Between
pin 13 (Tap) and this wire, is a pre-installed auto-resettable fuse, which is provided to protect the wire between the sensor board and the DC-UPS
control unit. The maximal allowed charging current is 3.5A.
Headquarters: PULS GmbH, Elektrastr. 6, 81925 Munich, Germany, www.pulspower.com
Germany +49 89 9278 0
China +86 512 62881820
France +33 478 668 941
North America +1 630 587 9780
The information in this document is believed to be accurate and reliable and may change without notice.
Sensor Board for Battery Modules
Sensorplatine für Batteriemodul
Platine pour pack batterie
Placa de sensor para módulo de batería

Wiring Assignment

Austria +43 2764 3213
Singapore +65 6684 2310

Technical Data

Max. wire size (litz wire) 1.5mm²
Wire size AWG AWG 20-14
Max. wire diameter 1.5mm
Wire stripping length 6mm / 0.25inch
Tightening torque 0.5Nm / 4lb.inch
Size (length x width x height) 110.5x23x15mm
Weight 85g / 0.19lb
Switzerland
United Kingdom +44 1525 841001
+41 56 450 18 10