Importing Backup Data - Daihen OTC Welbee P402L Owner's Manual

7
A
C
DMINISTRATOR
HAPTER
D B
ATA ACKUP
7.3.6

Importing backup data

This section explains how to import the backup data.
NOTE
•
1.
Turn ON the power switch.
2.
Insert the USB flash drive to the USB connector of the operation panel.
3.
Display "RESTORE" on the MENU screen.
Turn the screen operation knob to place the cursor on
●
"RESTORE", and press the knob.
 "ALL" or JOB No. (registration No.) is displayed on the
right digital meter in a flashing mode, and the LED of
"JOB" lights up.
 "USb" is displayed on the left digital meter.
4.
Select the data to import.
Turn the parameter adjusting knob further
●
counterclockwise to display the data to import on the right
digital meter.
 The display changes in order of "ALL" -> "1" -> "2".
"ALL" means that all the data ("1" to "2") available for importing are
•
selected.
Details of the numbers displayed (
•
data))
5.
Press the screen operation knob.
 Flashing of the left/right digital meter displays will stop,
and the display changes to the light-up mode.
128
F
UNCTIONS
(U )
TILIZATION OF DATA
The data stored in the welding power source will be overwritten by the backup data. Make
sure of it before overwriting.
7.3 Data Backup (Utilization of
-