CAME MTMRFID Programming Manual
  1. Manuals
  2. Brands
  3. CAME Manuals
  4. Rfid Systems
  5. MTMRFID
  6. Programming manual
CAME MTMRFID Programming Manual

CAME MTMRFID Programming Manual

Rfid module for access control
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

RFID module for access control
FA01679-EN
MTMRFID
EN English
PROGRAMMING MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MTMRFID and is the answer not in the manual?

Questions and answers

Summary of Contents for CAME MTMRFID

  • Page 1 RFID module for access control FA01679-EN MTMRFID EN English PROGRAMMING MANUAL...

  • Page 2: General Precautions

    • Before carrying out any cleaning or maintenance, disconnect the device from the power supply. • Only use this product for its intended purpose. Any other use is hazardous. • Came S.p.A.
  • Page 3 Associating badges This procedure lets you associate a badge with one of the two relays present on the MTMRFID module: ON Associating badge with relay 1 (NC, NO, C1 terminal) Associating badge with relay 2 (NO, C2 terminal) To associate badges with the selected relay, position DIP1 to ON ❶. When the...
  • Page 4 To remove badges, put the RFID PROG jumper of the power supply in the “-” ❶ ❷ position ❶. When the red LED on mod- ule MTMRFID starts to fl ash slowly ❷, swipe the badges to be removed on the reader twice. beep beep A beep will confi...
  • Page 5 PROGRAMMING IN SLAVE MODE VA/01 VA/08 SLAVE SLAVE Programming relay codes with badges (only with audio module MTMA/01 and video module MTMV/01) For operating details refer also to the manual for audio module MTMA/01 and video module MTMV/01. Programming relay codes lets you manage the relays present on audio module MTMA/01, video module MTMV/01, or any eventual VLS/2, via badges.

  • Page 6: Exiting Programming

    In the event of an error, this will be indicated by 3 fast beeps. Repeat the stage correctly. Sequence Command + swipe badge on module MTMRFID on the entry panel to be pro- Relay 1 on module VLS/2 grammed + swipe badge on module MTMRFID on the entry panel to be pro-...
  • Page 7 Swipe the badge to be programmed. If the badge is valid, the LED on the entry panel stays constantly on and it is possible to continue with programming Press the call key of the group the beeeep beeeep VA/01 - VA/08 VA/01 - VA/08 badge is to be associated with.
  • Page 8 CAME S.p.A. Via Martiri Della Libertà, 15 31030 Dosson di Casier - Treviso - Italy tel. (+39) 0422 4940 - fax. (+39) 0422 4941 info@came.com - www.came.com...

Table of Contents