Epson WorkForce 60 Start Here page 2

4
Load paper
You can load letter-, A4-, or legal-size paper, as well as
4 6-, 5 7-, or 8 10-inch photo paper. For instructions on
loading legal-size paper, see the online User's Guide.
1
P ull out the paper cassette and lift off the paper cassette
cover.
2
S lide the edge guides outward.
3
P osition the guide shown below for the size of paper
you're using.
4 6-inch
4
I nsert the paper with the glossy or printable side face-
down.
4 6-inch
N ote: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
5
S lide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
4 6-inch
Letter-size
LTR
Letter-size
Letter-size
6
R eplace the paper cassette cover, then gently insert the
paper cassette.
N ote: The paper may slide forward slightly as you insert the
cassette. This is normal.
7
Extend the output tray as shown.
5
Choose your connection
You can connect your printer to your existing network
(wireless or wired) or directly to your computer using a USB
cable. See below for details on each connection method.
Wireless Connection
You must install the software on every computer from which
you want to print. For the first installation, we recommend
using a USB cable to simplify wireless setup. After the printer
is connected to the network, you will be prompted to remove
the cable.
M ake sure you know your network name (SSID) and network
password:
• Network name
• Network password
If you don't have this information, contact the person who set
up your network.
Direct USB Connection
Make sure you have a USB cable. Do not connect the printer
to your computer until you're instructed to do so.
Wired Ethernet ® Connection
Make sure you have an Ethernet network cable (not included).
You must install the software on every computer from which
you want to print.