Monster MGPELLET Owner's Manual page 12

11. Install RTD Temperature Sensor
[5] RTD Sensor
[F] M4 x 10 Bolt – 1pc
[G] M4 Hex Jam Nut – 1 pc
Begin by placing the Hopper
Assembly into the end panel of
the Cooking Chamber. Let it rest
as needed to prevent it from
falling out.
Manoeuvre the RTD sensor tip
through the top hole so it is inside
the Cooking Chamber. Then inert
the M4 Nut from inside the
Cooking Chamber.
12. Connect Hopper Assembly
[6] Hopper Assembly
[7] Tray Bucket
[B] M6 x 20 Hex Head Bolt – 4 pcs
Now lift the Hopper Assembly so
it can slide into the Cooking
Chamber. From inside the
Cooking Chamber, loosely attach
the two lower M6 Bolts FIRST.
Now attach the Tray Bucket
inside the Cooking Chamber by
inserting two M6 Bolts through
the chamber end panel into the
Hopper Assembly.
Tighten all bolts.
12