Download
Share
Print this page
  1. Manuals
  2. Brands
  3. RFbeam Microwave Manuals
  4. Test Equipment
  5. K-DT1
  6. User manual

RFbeam Microwave K-DT1 User Manual

Portable radar doppler target
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
K-DT1 Portable Radar Doppler Target
User Manual
© RFbeam Microwave GmbH www.rfbeam.ch
Page 1/9

Advertisement

loading
Need help?

Need help?

Do you have a question about the K-DT1 and is the answer not in the manual?

Questions and answers

Summary of Contents for RFbeam Microwave K-DT1

  • Page 1 K-DT1 Portable Radar Doppler Target User Manual © RFbeam Microwave GmbH www.rfbeam.ch Page 1/9...

  • Page 2: Getting Started

    13.4kHz polarized antenna. You can use K-DT1 in any corresponding to speeds from 1km/h to 300km/h. Getting Started This chapter explains the first steps of using the K-DT1 device and the DT1-Remote Software. Equipment Needed RFbeam K-DT1 Device ● Four Size AA Batteries ●...
  • Page 3 4. Please be patient while LabVIEW runtime system is being installed. 5. You will find DT1-Remote under START-PROGRAMS-RFbeam-DT1 Remote 6. Plug your K-DT1 system to a USB port of your PC. There should appear a “New USB Hardware Found” message from Windows.
  • Page 4 2. Repeat pressing the Preset selector (2) until the desired preset LED (5) flashes > after 1 second, the selected LED (5) stops blinking and K-DT1 runs the selected preset > the selected preset will become the new default preset Playing Around If you own an RFbeam Starterkit (http://www.rfbeam.com/81.0.html), you may test all the K-DT1...
  • Page 5 Remote Controlling K-DT1 K-DT1 may be remotely controlled by the DT1-Remote software. The realtime remote control part is called Live Setting on the left half of the Software panel. Please connect K-DT1 to a USB port before changing any controls.

  • Page 6: Getting Help

    2. Save presets with control (10) Set Default Preset Default preset will be active after normal power on of the K-DT1. It may later be altered directly at the K-DT1. 1. Select default preset with (8) 2. Save presets with control (10) Getting Help Get help by selectig Menu-Help.
  • Page 7 [x] Back to manual mode -> Fig. 4: K-DT1 Terminal Remote Control Dialog These settings are directly executed, as long as K-DT1 remains connected to the USB port. With [p], you will be able to configure the preset memory. Terminal Mode: Preset Setting For using presets please refer to chapter Using K-DT1.

  • Page 8: Ordering Information

    Serial USB, Mini-USB connector Body Outline Dimensions 68x128x24 Weight Including batteries Accessories Case protection, Softcase, USB Cable, USB Memory Stick, 4 AA-size Alkaline Cells, Windows Software “DT-1 Remote” Ordering Information Part #: RFbeam K-DT1 © 2019 RFbeam Microwave GmbH www.rfbeam.ch Page 8/9...
  • Page 9 No. K-DT1 is powered by the USB port during a host connection. How can I measure frequency and RF power of my transceivers? K-DT1 is only a Doppler Simulator. For power and frequency mesurements, you may use the RFbeam K-TS1 system.