Summary of Contents for KegLand DIGIBOIL 35L
- Page 1 DIGIBOIL(35L/65L) Digital Turbo Boiler Welcome to the DIGIBOIL community! To ensure you have the best possible experience with your DIGIBOIL please read this instruction booklet carefully.
- Page 2 Safety Information: To prevent injury to yourself or others, and to avoid damaging the appliance, please read and follow the safety precautions below before setting up and using the unit: • Remove all packaging and plastic coatings from the appliance •...
- Page 3 Operation Display Buttons & Indicators: (+) Increase Temperature. (-) Decrease Temperature After setting the temperature, the set temp will flash for 4 seconds and then return to the actual temperature. To change the unit into Degrees Fahrenheit , press and hold both the (+) and (-) for three second until the screen flashes.
- Page 4 Power: Rocker I(ON)/O(OFF) switch Located on the left side of the display panel. The rocker switches will also illuminate when turned on. Heating: Default temperature = 100 C with a range of 0-100C. Please note the unit can only heat. Not cool. You can also manually adjust the amount of watts your Digiboil outputs.
- Page 5 Error Codes: E1 = Probe is open circuit (not connected/loose wire(s)/board failure) E2 = Probe short circuit (probe failure/board failure) E3 = Thermal cutout switch activated (Boiled dry?) Technical Specification: Warning: •The appliance must be on a flat, horizontal surface. •Ensure that safe operational access to the appliance is unrestricted.
Need help?
Do you have a question about the DIGIBOIL 35L and is the answer not in the manual?
Questions and answers