AP Bio-Dri II Instructions

1004 East Illinois Street • Assumption, IL 62510 • 1-217-226-4421

Inlet Door Assembly Instructions

1. Construct frame and rough opening for inlet door. Ensure that the inside surface of both rough
openings is 3'' from the inside corner of the door hinge according to detail.
2. Assemble two (2) hinges (B) to top and bottom of door (A), using bolt (C) and nylock nut (D).
With two (2) persons, lift door and hinges over rough opening on inside of air mixing chamber and
center vertically. Ensure that the corner of the hinges are against the inside corner of the framing as
shown in Figure 1. Secure door and hinges to frame with four (4) lag screws (E) through each of the
four (4) hinges (B) and into the framing.
Inside corner for
door hinge
Ref # Part #
A AP-5292 Inlet Door 4' x 6' Black
B AP-5291 Inlet Door Pivot Frame Support - Hinge
C S-7935 Bolt, HHCS 1/2''-13 x 1'' ZN Grade 5
3. According to Figure 2 on Page 2.
to hinge. Ensure it is centered vertically within the rough opening and secure with four (4) lag screws
(E) into the framing. Also vertically centered on opposite side of rough opening, install short straight
brace (H) and secure with four (4) lag screws (E) into the framing.
4. Install the tubular brace (J) to the lower hole on the outer face of the short straight brace (H). Rotate
the tubular brace downward to about 45° until the bottom end fits inside the rough opening. Secure
with a lag screw (E) to the framing.
5. Install the bottom anchor plate (I) between diagonal and straight braces, using four (4) bolts (L) and
four (4) nylock nuts (M).
6. Lay linear actuator (F) on top of bottom anchor plate (I) and connect rod end of actuator to pivot hole
in door. Secure rod connection with bolt (N) and nylock nut (D).
7. Lay top anchor plate (I) on top of linear actuator (F), diagonal brace (G) and straight brace (H),
then install long pivot bolt (K) through top anchor plate, actuator and bottom anchor plate. Secure
with nylock nut (D). Align top anchor plate mounting holes with diagonal brace and straight brace.
Secure with four (4) bolts (L) and four (4) nylock nuts (M).
Date: 05-06-16 V1.0
Printed in the U.S.A.
Copyright © 2016 by The GSI Group, LLC
www.gsiag.com
Figure 1
Description Qty
Install long diagonal brace (G) to inside of rough opening closest
Bio-Dri II™ Air Inlet Door
Assembly Instructions
Ref # Part #
1 D S-8260 Nylock Nut 1/2''-13 ZN Grade 5
4 E S-7308 Lag Screw 3/8'' x 2'' HH ZN
2
PNEG-1984
Instructions
(See Figure 1.)
Description Qty
2
16
PNEG-1984
Page 1 of 4
CN-324780