Advertisement
CAUTIONS & WARNINGS
!
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in
!
damage or personal injury.
CAUTION: To avoid overheating and possible damage to this product and other equipment,
!
do not use to power a device which exceeds the designed ratings.
CAUTION: This product must be installed and/or used in accordance with the
!
appropriate electrical codes and regulations. Plug into 120V grounded outlet only.
WARNING: Avoid getting any liquid on the unit, as it can cause shock & fire. If unit gets wet,
!
disconnect the power at the circuit breaker, fuse or outlet. Ensure the unit
is completely dry before connecting this product to a power source.
WARNING: If unit fails to operate, it should be discarded. Do not open the unit or try to service it.
!
CAUTION: The UPLIFT Clamp-on Power with USB needs a path to ground to work properly,
!
and should only be plugged directly into a grounded outlet. Using any extension cord in con-
junction with an UPLIFT Clamp-on Power with USB will void all UPLIFT warranties. All con-
nected equipment should be plugged directly into your UPLIFT Clamp-on Power with USB.
©
Copyright Notice: This guide is a component of the Clamp-on Power with USB. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or
copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
Step 2
Use the 2.5mm Allen wrench to remove all four Set screws from
the two brackets that shipped installed on the Main unit. Then
slide the two brackets off of either side of the unit. Keep two of
the Set screws for use in the next step.
Note: these brackets may be tight but they will come off.
Step 3
After removing the two brackets that shipped installed to the
Main unit, slide the Main unit onto the installed Desktop bracket
as shown.
Once the Main unit is aligned underneath the Desktop bracket,
reinstall two of the Set screws removed in the previous step to
lock the unit in place and keep it from sliding off the Desktop
bracket.
AI-PDC003-2.1
Advertisement
