Advertisement
Management and configuration via blukii Manager and Configurator App
The cloud-based blukii Manager acts as a central tool for managing and configuring your Smart Beacons. Device settings can be
made here, which can then be transferred to the corresponding beacon using the blukii Configurator app. Changes made in the app
are transferred to the blukii Manager.
To change the settings of your Smart Beacon, proceed as follows:
1.
Log in to https://manager.blukii.com/ with your blukii Manager account.
2.
In the "My blukiis" section, click on the blukii for which you want to change the settings.
3.
Make the desired changes and apply them by clicking the "Save" button
4.
Place your smartphone near the appropriate beacon and start the blukii Configurator app
5.
Select the corresponding blukii to get to the "Device Info" view. The orange cloud in the General section indicates that
there are changed settings.
6.
Now tap on the blue edit button at the bottom right and wait until the connection to the beacon has been established.
7.
The Update area now appears in orange. Tap the "Update Device" button here to transfer the parameters changed in the
blukii Manager to the beacon.
8.
If you now exit the configuration view, a dark blue cloud shows that the data has been successfully synchronized and is
up to date.
Parameter changes can also be made directly via the blukii Configurator app. To do this, proceed as follows:
1.
Place your smartphone near the corresponding beacon and start the blukii Configurator app
2.
Select the blukii for which you want to make changes
3.
Then tap in the "Device Info" view on the blue edit button at the bottom right and wait until the connection to the beacon
has been established.
4.
Make the desired changes and apply them by clicking on the "Save" button
5.
After leaving the "Configuration view", the changes are transferred to the blukii Manager
Changing batteries
To change the battery of your Smart Beacon Outdoor Mini 5400, please proceed as follows:
1.
Open the housing cover, loosen the two screws holding the circuit board and remove the circuit board.
2.
Pay attention to the battery instructions in the next section
3.
Insert the new batteries according to the markings. The negative pole of both batteries must be on the side of the
Bluetooth board.
4.
Put the circuit board equipped with new batteries back into the housing and fasten it with the appropriate screws.
5.
Close the housing cover.
Battery notes
Do not use rechargeable batteries!
•
Rechargeable Batteries usually have a higher internal resistance and lower voltages. This can lead to incorrect runtime
estimation and reduced operating time.
•
Use high quality batteries!
EVE ER14505 Lithium Thionyl Chloride Batteries are suitable for operating your Smart Beacon Outdoor Mini 5400
•
Risk of explosion!
o
Do not recharge, short-circuit or disassemble batteries!
o
Immediately remove empty batteries from the Smart Beacon Outdoor Mini 5400
o
Keep batteries away from children and avoid contact with eyes, skin and mucous membranes. If you come into
contact with battery acid, wash out immediately with clear water and consult a doctor.
Help in case of errors
Error
Smart Beacon is not detected in the
Configurator app
Smart Beacon is not detected in the
Configurator app
The connection with blukii
Configurator App fails.
Notification: blukii connection failed!
Manual Smart Beacon Outdoor Mini 5400
Cause
The slider for the RSSI value is too low
The Smart Beacon is out of range
The Smart Beacon is not assigned to your
blukii Manager account
Made in Germany
Remedy
Raise the threshold to get more distant
beacons on the display
Make sure that the beacon is in the
immediate range of your smartphone
Add the blukii to your blukii Manager
account. See section "Add Smart
Beacons in the blukii Manager"
16.01.2023
Advertisement
