Summary of Contents for Precision WRDLW484K30L
- Page 1 Model: WRDLW484K30L SKU: 10065 USE AND CARE GUIDE Dim Low Watta e Wrap 1-866-237-9983 service@precisioncpg.com...
-
Page 2: Table Of Contents
Consult the dealer or an experienced radio/TV technician for help. approved by the party responsible for compliance could FCC responsible party ： void the user’s authority to operate the equipment. Precision Consumer Products Group, LLC. 11024 Balboa Boulevard Suite 1710 Granada Hills, CA 91344 1-866-237-9983 Warranty WHAT IS COVERED products used in normal use and service. -
Page 3: Pre-Installation
Pre-Installation PLANNING INSTALLATION Before beginning assembly, installation, or operation of the product, make sure all parts are present. Compare parts with the package contents list. If any part is missing or damaged, do not attempt to assemble, install, or operate the product. -
Page 4: Junction Box Installation
Pre-Installation (continued) before drilling. WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or CAUTION: Before beginning installation turn off the circuit breaker and light switch. Junction Box Installation Installing the screws Install the two screws (AA) into the junction box (1). - Page 5 Junction Box Installation (continued) Wiring the fixture Attaching the fixture Before wiring, temporarily connect the male and female quick connectors (1) to determine the placement of the black and white power screws on the junction box. supply wires. Then, separate the quick connectors.
-
Page 6: Keyhole Installation
Keyhole Installation Removing the lens sliding the lens access tabs (C) out from the end Gently lift and remove the lens (B) from where the lens access tab was removed. Removing the knockout cables through the knockout hole. Positioning the fixture of the four keyhole slots at each end of the housing. - Page 7 Keyhole Installation (continued) Mounting the fixture through Mounting the fixture to a wall drywall stud If the mounting holes go through drywall If the mounting holes align with wall studs, without a stud, drill a small pilot hole with drill a pilot hole using a 5/32” drill bit (not 1/8”...
- Page 8 Keyhole Installation (continued) Attaching the fixture Hide the wires in the junction box and guide the heads of the four wood screws (CC) into the keyhole slots. to the mounting surface. Attaching the lens Replace the lens access tabs (C).
-
Page 9: Care And Cleaning
Compatible standard dimmers These fixtures are fully dimmable using a standard household LED rated dimmer. THEY DO NOT REQUIRE A SPECIAL 0-10V DIMMER. If connecting a dimmer, please use the instructions provided with that device. Brand Model Specification LUTRON DVCL-153P 120V,60Hz,150WCFL/LED,600W/Incandescent LUTRON CTCL-153P... - Page 10 1-866-237-9983 Email: service@precisioncpg.com...