Magnani 210124 Manual

MANUAL: STAINLESS STEEL KITCHEN SCALES
WITH BOWL - MODEL NO.: 210124
GENERAL INFORMATION:
• In order to guarantee safety and maintain the quality of the product,
please read all instructions prior to use. Store this manual. If you give this
appliance to someone else, please also give them these instructions.
• Only use this product according to the instructions in this manual.
• Clean the scales/housing with a slightly damp cloth.
• Not intended for professional use.
WARNING:
• Never load the scales with more than their maximum capacity. Although
the scales are designed for extreme durability and have a built-in
overload protection, overloading will permanently damage the scales.
• Avoid any exposure to extreme heat or cold. The scales work best when
used at normal room temperature.
• Always allow the scales to reach room temperature for at least an hour
prior to use. Allow your scales sufficient warming up time. Normally 30-60
seconds for calibration, to give the internal components the opportunity
to stabilise.
• Store the scales in a clean environment. Dust, dirt, moisture, vibrations, air
streams and / or nearness to other electronic equipment could all have a
negative effect on the reliability and accuracy of your scales.
• Carefully place all the products to be weighed on the scales or in the bowl.
• Avoid shaking, dropping or other impacts on the scales. This could
damage the scales and sensors.
• Do not submerge the appliance in water or any other liquid to prevent
injury or damage to the product.
• Keep this product out of reach of children.
BEFORE USING THE PRODUCT FOR THE FIRST TIME
• Carefully read the manual, so you are able to use the product correctly
and damage and injuries are prevented.
• Wash the bowl prior to first use.
• Use the correct batteries (2x AAA battery) and make sure they are installed
with the correct polarity.
• When this product is not used for a long period of time, remove the
batteries to prevent possible damage caused by leaking batteries.
SYMBOLS ON THE SCREEN
Alarm and timer.
Temperature and measuring unit.
The weight is being measured.
Negative reading.
Zero weight.
Unit in kilos.
Unit in grammes.
Unit in pounds.
Unit in ounces.
On/Off.
Press for TIMER setting, press briefly for temperature setting.
Press to switch on the weighing mode.
Press to read the weight. TARE appears on the LCD screen
and the reading goes to zero.
USE
1. Place the scales on a hard, flat surface.
2. If the bowl is required, place it on the scales.
3. Briefly press the on/off button.
4. Wait until the screen indicates "0".
5. Carefully place the product to be weighed in the bowl or on the scales.
6. The weight can be read on the screen.
CHARACTERISTICS
START UP SCREEN
When the appliance is switched on for the first time, all the functions of the
display are shown. This screen will remain for about 3 seconds and then go
to "0".
OVERLOAD INDICATOR
If the display shows "Err", this indicates an overload. Immediately remove the
excess load. Caution: the scales could be permanently damaged when they
are overloaded.
LOW BATTERY INDICATOR
If the display shows "Lo" , this indicates that the batteries are almost empty.
The batteries must be replaced for the scales to function properly.
TEMPERATURE
The current temperature is shown in the top left corner of the LCD screen.
The range is from 0 °C to 40 °C in steps of 0.5 °C. The temperature can be
converted to Celsius or Fahrenheit by briefly pressing the "T-SET" key.
EN
KEY FUNCTIONS
1