Page 1
Operator’s Manual WARNING! Read this Operator’s Man- ual carefully before using this tool. Failure to under- For support and additional informa- stand and follow the con- tion about using your NANOreel go to tents of this manual may result in electrical shock, support.seesnake.com/nanoreel or fire, and/or serious per- scan this QR code.
UK lmporter This symbol means read the op- Ridge Tool UK (RIDGID) erator’s manual carefully before 44 Baker Street using the equipment. The manual London W1U 7AL, UK contains important information on the safe and proper operation of the equipment.
Damaged or entangled cords increase same time, wear RIDGID drain clean- the risk of electric shock. ing gloves. Never grasp the rotating drain cleaning cable with anything else,...
Accessories that may cause hand injuries. Only wear latex or rubber gloves underneath RIDGID drain be suitable for one piece of equipment cleaner gloves. Do not use damaged may become hazardous when used with drain cleaning gloves.
Pre-Operation Inspection 8. Observe the work area and erect bar- riers as necessary to keep bystanders WARNING away. See additional product specific safety in- formation and warnings starting on page To reduce the risk of serious injury from electrical shock or other causes, and to prevent damage to your equipment, in- spect all equipment and correct any problems before each use.
P-traps, and very small radius bends which conventional inspection NANOreel can also be used with the hand- held RIDGID micro CA-350 inspection systems often cannot inspect. The included monitor with the docking handle accessory, kickstand lets you set up the NANOreel sold separately.
Specifications Specifications ‡ The NANOreel will traverse a 1 in [25 Weight 5.5 kg [12.1 lb] mm] straight pipe, but its ability to Dimensions: go past 90-degree turns will depend on the material and construction of Length 337 mm [13.3 in] individual pipes and joints.
Components Carry Cord Wrap Handle Rear Case SeeSnake System Cable Case Front Latch Case Push Cable Guide Kickstand Slip-Ring Module Feet Serial Number Label Camera Camera Head Clip Camera Head Push Cable Case Latch Removable Push Cable Drum NANOreel – English – 9...
This section contains important safety drum is removed from the case or if information that is specific to the RIDGID the case is left open with the drum in- See Snake NANOreel. Read these precau- side.
Operating Instructions Opening the NANOreel Case WARNING Placement Make sure the camera is completely in- Set up your NANOreel near the pipe en- side the drum before unlatching and trance so you can manipulate the push opening the NANOreel case. Do not open cable while viewing the display.
Installing the Drum Inspection Overview The NANOreel case gives you the ability to To perform a pipe inspection, connect any swap out the drum when the job requires a See Snake monitor to the reel, power on the different push cable and camera combina- system, push the push cable through the tion.
Removing the Slip Ring Connecting to the CSx Via Assembly The CSx Via Wi-Fi inspection device can be connected to the NANOreel through the 1. Disconnect the system cable from the slip-ring cavity. Remove the slip-ring assem- reporting monitor and remove the mon- bly from the NANOreel and install the CSx itor from the docking system.
Maintenance and Using Guide Tubes Support Use guide tubes, such as PVC or flexible tubing, to avoid marring or scratching Cleaning porcelain surfaces. Clean the micro CA-350 or monitor in accordance with its operator’s manual. Before cleaning the NANOreel, remove the micro CA-350 from the display cradle.
2006/66/EEC. Service and repair of the camera reel must be performed at a RIDGID Independent Authorized Service Center. To find your nearest service center or for any service or repair questions: •...
Page 16
RIDGID and the RIDGID logo are trademarks of Ridge Tool Company, registered in the USA and other countries. All other registered and unregistered trademarks and logos mentioned herein are the property of their respective owners.