Advertisement
Advertisement
Table of Contents
Summary of Contents for PSP SunGlaze
- Page 1 SunGlaze Installation Guide info@psp.co.nz 0800 786 883 www.suntuf.co.nz...
-
Page 2: System Components
Top and bottom fixing points is recommended NOTE: Recommended roof pitch 5°. Minimum roof pitch of 3°, consult your PSP agent for suitable applications. A Left and Right Edge End Cap is included. One is to be ClearVue... - Page 3 SEE PAGE 6 for spacer bar use. ‚ PURLIN SPACING To install SUNGLAZE directly on purlins, the purlins must be the same distance apart from each other. ‚ The maximum distance between purlins for SUNGLAZE is 1200mm on centres. ‚...
-
Page 4: Before Installation
Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Before Installation Before drilling holes, place the Bottom & Edge Bottom Glazing Bars over a strip of wood. This will protect the end of the drill bit as it penetrates the profiles. - Page 5 Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Before Installation Remove the protective film from the bottom of the Panel before installation. Fastening Flush End Caps. Bottom side only! Flush End Caps for Edge Bottom Glazing Bars Flush End Caps for Bottom Glazing Bars Note: Edge Bottom Glazing Bar is to be installed if a cut panel is required.
- Page 6 Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Installation Place the first Roof Panel between the installed Bottom Glazing Bars. Do not install more than two Bottom Glazing Bars at a time. Otherwise, you risk accumulated measurement deviations across the roof.
- Page 7 Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Installation Installing Middle Glazing Bars The Middle Glazing Bar must be fully fastened before adding the top cap. Installing Middle Glazing Bar It is very difficult to remove the Middle Glazing Bar after installation.
- Page 8 Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Installation Installing Edge Bottom Glazing Bars with cut Roof Panels. Measuring Roof Panels for left/right side of roof If you do not need to rip cut your final two roof panels, skip to step 14. You will rip cut the final left and right Roof Panels to fit (if required) before you install the Edge Bottom Glazing Bar.
- Page 9 Installation Guide: SunTuf SunGlaze Superior Residential Polycarbonate Glazing System Installation Install the Edge Middle Glazing Bar on either the left and right side Edge Bottom Glazing Bar. Fixing both the left and right side Edge Bottom Glazing Bar. NOTE: Use Cordless drill.
- Page 10 Remove the protective film after each Roof Panel is fully installed and secured. Please note: SunTuf SunGlaze is weather resistant not waterproof. All flashings and junctions that are installed must comply with local building regulations and the responsibility of the installer.
Need help?
Do you have a question about the SunGlaze and is the answer not in the manual?
Questions and answers