Viewtech 4-port PoE Switch with 1 Uplink Port User Manual

10/100Mbps
Switch
with
4-Port
PoE
User
Manual
This Product is an unmanaged PoE switch, provides 4*10/100Base-TX PoE ports +
1/2*10/100Base-TX RJ45 ports. Max PoE power output for single port is 30W, the total PoE
power budget is 60W. Providing three operating modes (Default, VLAN, CCTV). The switch
supports PoE watchdog under VLAN and CCTV mode. It improves the online rate of
cameras.

Application

PoE I P Camera
PoE Dome Camera
PoE I P Camera
PoE P T Z Camera

Feature

4*10/100Base-TX Ethernet ports (PoE ports) and 1/2*10/100Base-TX uplink port.
Support IEEE802.3af/at standards, Max.30W output of single port.
Three operating mode:
Default: All ports can be communicated freely.
VLAN: Port 1-4 are isolated respectively, but can communicate with uplink ports, support
PoE watchdog.
CCTV: The transmission distance can be extended to 250 meter, while link speed of
downlink ports 1~4 will be limited to 10Mbps(Uplink ports keep 100Mbps). Support PoE
watchdog.
6KV surge protection, 8KV ESD immunity and anti-interference.
Easy & safe installation: wall-mounting, desktop.
Plug-and-play.

Notice

The
transmission
distance
is
related to the
connected
cable.
We
suggest
standard

Cat5e/6 network cable, so the transmission distance can up to100m!
1

Board Diagram

13.238.101.1758
V2.0
Front
board
of
4-port
PoE
Switch
with
1
Uplink
Port

Front
board
of
4-port
PoE
Switch
with
2
Uplink
Ports

L C
D
Description：
The
equipment must connect the ground according to the request.
User
Manual

Installation
steps
Please
check
the
following
items before installation, if it is missing, please contact the
dealer
.
4 ports PoE Ethernet switch





























































Power
adaptor


























































































1pc





AC power cable


























































































Accessory

































































































User
manual















































































Please
follow
the below
installation
steps
1) Please turn off the signal power and display device power before installation,
installation with power will damage the transmission equipment.
2) Use network cable connect PoE IP camera and 1〜4 down link ports of
product respectively.
3) Use
a
network
cable connect equipment uplink port and NVR or computer.
4) Turn
on
the
power of the equipment.
5) Check if the installation is correct, equipment is in good condition, the connection
is stable, then provide power for system.
6) Ensure
the
Ethernet
equipment
with
power
and
work
properly.
10/100Mbps
Switch
with
4-Port
PoE
Power Input Port PoE Downlink Ethernet Port Uplink Ethernet Port
Power Input Port PoE Downlink Ethernet Port
DIP switch
Grounding
Grounding
6
Uplink Ethernet Port





1pc




1pc








1set













1set
2