Summary of Contents for FlexPro EOL Series
- Page 1 POWER WIND GENERATOR General information and installation guide WWW.FLEXPRO-INDUSTRY.COM All right reserved © All right reserved...
- Page 2 Series EOL Series EOL : EOL/1000 EOL/2000 EOL/3000 EOL/500 EOL/5000 EOL/10000 EOL/20000 EOL/300 Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
-
Page 3: Installation Procedure
3. Four annular anchors need to be deposited 60°to 80°along the base direction and check the distance between the four hooks of the anchors and the center of the base (6M) and four anchors should be horizontal. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com... - Page 4 15°and examine the tight wire’s tensile force on both sides. Any over tight or loose wire should be regulated by putting down the tower slowly and adjusting the length of tight wire. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 5 It is unnecessary and not advised to open any other parts of the inverter but the connection terminals by the qualified personnel. All electrical installations shall be done in accordance with the local and national electrical codes. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 6 If the voltage remains above 70Vdc, the inverter will synchronize with the utility and begin exporting power. When the DC voltage reaches 120Vdc, inverter will output 1500 Watts AC to the utility. And the inverter will Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 7 8. The wrong states of the inverter DC input wrong The Fault LED (red) blinks one time and off three second and blinks again Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 8 If there is a fault of the IPM module then this screen may display “Module Fault”; If there is a fault of the communication of system then this screen may display “COM. Fault”. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 9 (-25°C to 60°C). Direct Sunlight on the inverter must be avoided. It should be protected from sunlight by mounting a shading screen in front of the device. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 10 WARNING: When this has been done, always waiting for approx.5 minutes so that the capacitors in the inverter can be discharged. Only then may the lid be opened and the safe isolation from power supply checked. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 11 AC outlets or device may be connected to this circuit. The cooling air enters at the bottom and exhausts at the top of the unit. Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...
- Page 12 * The color of photographs may be different from real objects. * No notification if the manual modified. *The guarantee of turbine is 2 years, and the inverter is 1 year since the date of purchase (non-done by man ) Tel: 00852-3065 8400, Fax: 00852 3610 2779 http://www.flexpro-industry.com E-Mail: contacts@flexpro-industry.com...