Do you have a question about the xFIRE and is the answer not in the manual?
Questions and answers
Michael Mullins
May 31, 2025
I have no sound, and it's a month old and barely used??
1 comments:
Mr. Anderson
May 31, 2025
Possible causes of no sound from the Technical Pro xFIRE after one month of use include:
1. The unit is on mute. Press the Mute button to unmute. 2. The volume is too low. Press and hold the VOL+ button to increase volume. 3. The unit is in standby mode. Press the Standby button to switch to AUX or another input mode. 4. Incorrect input mode is selected. Use the Input Mode Selector Button to choose the correct input (e.g., AUX, FM, USB, BLUETOOTH). 5. No media is inserted or connected. Ensure a USB, SD card, or Bluetooth device is connected if using those modes. 6. The track is paused. Press the Play/Pause button to resume playback.
Check each of these to restore sound.
This answer is automatically generated
Kylie McClelland
April 5, 2025
How do you control the LED’s
1 comments:
Mr. Anderson
April 5, 2025
The LEDs on the Technical Pro Xfire Fireplace Entertainment Center are controlled using a wireless remote.
This answer is automatically generated
Michael Sparrow
May 2, 2025
I need a replacement for the part in the photo
Christian Saffo
May 2, 2025
I need a replacement remote for my Xfire stereo system. And also a replacement
Gamaliel Russell
March 6, 2025
Where are the fuses located on my xfire bluetooth speaker
Page 8
1.Standy: Press this button to switch standby, and press it again to switch AUX. 2.Input Mode Selector Button: When there is NO USB or SD Card inserted into the unit, press this button to change between the following input modes: AUX-FM-BLUETOOTH. When there is a USB or SD Card inserted into the unit, press this button to change between the flowing input modes: USB/SD-AUX-FM-BLUETOOTH.
Need help?
Do you have a question about the xFIRE and is the answer not in the manual?
Questions and answers
I have no sound, and it's a month old and barely used??
Possible causes of no sound from the Technical Pro xFIRE after one month of use include:
1. The unit is on mute. Press the Mute button to unmute.
2. The volume is too low. Press and hold the VOL+ button to increase volume.
3. The unit is in standby mode. Press the Standby button to switch to AUX or another input mode.
4. Incorrect input mode is selected. Use the Input Mode Selector Button to choose the correct input (e.g., AUX, FM, USB, BLUETOOTH).
5. No media is inserted or connected. Ensure a USB, SD card, or Bluetooth device is connected if using those modes.
6. The track is paused. Press the Play/Pause button to resume playback.
Check each of these to restore sound.
This answer is automatically generated
How do you control the LED’s
The LEDs on the Technical Pro Xfire Fireplace Entertainment Center are controlled using a wireless remote.
This answer is automatically generated
I need a replacement for the part in the photo
I need a replacement remote for my Xfire stereo system. And also a replacement
Where are the fuses located on my xfire bluetooth speaker
how do I get replace remotes for xfire