Advertisement
Advertisement
Table of Contents
Summary of Contents for MONITOR PRO MP-TS2
- Page 1 QUICK START GUIDE WIRELESS TEMPERATURE MONITORING...
- Page 2 The Monitor Pro solution takes temperature readings 24/7 and alerts you when there is an issue. Best of all Monitor Pro seamlessly integrates into the Safe Food Pro food safety platform. Additional Hubs and Sensors are available for purchase online from...
- Page 3 SETTING UP YOUR LORA WIRELESS HUB 1. The Wireless Hub needs to connect to your Internet router, and be placed in an area free from obstructions as these can interfere with the signal from the sensors. 2. Connect the power supply (supplied) to the Wireless Hub. The power supply light should glow Red. 3.
- Page 4 TEMPERATURE SENSOR 1. Place the Sensor in a Fridge or Freezer. 2. Take a note of the Sensor ID. This can be found below the barcode on the side of the sensor. 3. Choose an area back from the door and to one side. 4.
- Page 5 SAFE FOOD PRO SETUP 1. In the Safe Food Pro Admin Console (https:/ /my.safefoodpro.co.nz), choose ‘Equipment’ from the ‘Menu’ 2. Click the ‘Edit’ icon (pencil) on the fridge/freezer you have added the sensor to. 3. Scroll down the Wireless Monitoring section. 4.
- Page 6 TROUBLE SHOOTING I am not getting any temperature readings. 1. Check your hub is connected to your Internet Router. Do you have the Red light on, and the Green light flashing every few seconds? 2. If you don’t see the green light flashing, your network may have a firewall. In this case you need to get your network administrator to allow ‘outbound access through your firewall on port 3000’.
Need help?
Do you have a question about the MP-TS2 and is the answer not in the manual?
Questions and answers