AQ-Tron BAT/48344 User Manual

MANUAL

General Safety Guide:

•
Read owner's manual entirely & carefully. Please also read your vehicle's user
manual to make sure there are no specific precautions you should be aware of.
Use in a well ventilated area.
•
Please wear safety equipment, including safety glasses and gloves. Car batteries
produce explosive gases that can cause damages.
•
Do not submerge in water or put into fire. Do not connect clamps together, or
create a short circuit. And do not open the unit.
•
Never connect a 12V unit to a 24V vehicle or charger, and vice versa.
•
Charging DC jack: 12V input for 12V models, do not connect any 24V charger.
Always use original supplied charger adaptor. Do not use other accessories.
We recommend pre charging your start booster before use.

How to recharge it?

1. Pre charge it at home with the supplied charger only. Plug in the charger
adaptor into DC Jack plug and start recharging.
2. Recharge by an external battery, connect the two clamps of the batteryless start
booster on almost any charged 12V battery. The booster will get recharged by
this battery in very short time.
IMPORTANT: This Booster made with safety ON/OFF Switch. To open the
current (turn to Position ON), this allows the current to go through.
To close the current turn switch to (Position OFF), and this will prevent current
from going through.
3. Recharge by running vehicle engine, connect the booster clamps in correct
sequences on a running vehicle's terminals. Please make sure that the running
vehicle is 12V! Never recharge the 12V Booster by 24V vehicles!
IMPORTANT: This Booster made with safety ON/OFF Switch. To open the
current (turn to Position ON), this allows the current to go through.
To close the current turn switch to (Position OFF), and this will prevent current
from going through.
•
Make sure the unit is fully charged before using it: 5 LEDs lights must be ON, or
voltage must be higher than 13.5V.
•
If your unit is equipped with a safety fuse, please make sure the fuse is not
damaged; otherwise the current will not go through while recharging the unit
through the clamps by an external battery or by a running vehicle engine.
Make sure to connect 12V Start Booster to a 12V battery or vehicle,

How to use it?

•
If you can, pre-charge your unit beforehand.
•
Always make sure you use a 12V unit for a 12V vehicle, and vice versa.
www.aqtron.com - info@aqtron.com
USER MANUAL
BATTERYLESS START BOOSTERS
Max input voltage: 12V models: 14.8V
BAT/48344
The Battryl
charged al
battery. It w
Before & Af
1. Turn off
2. Make su
engage
3. Connec
4. Make su
5. Push th
6. Then Tu
starting
7. After di
towards
8. Put both
To recharg
minutes.
Warranty
Unit is cov
cover abus
Manufactu
under any
Plea
price of th
recy
facil
batt
use
man
envi
®