Page 1
VECTECH 190 SOLDERING TESTER Soldering iron temperature tester Instruction manual...
Page 2
source required to be used must have a ground wire. 9. When testing voltage and resistance, if the data exceeds the 1. Notes: specified value, check whether the tightening screw of the soldering iron tip is loose, tighten it, and then retest. 1.
Page 3
The life of a sensor varies depending on the flux and solder plug, just use the ground wire clip to connect the ground terminal, you use, and in general, a single sensor can measure up to you can complete the measurement. 50 times.
Page 4
Temperature KType thermocouple sensors LCD display ( LCD) 3.5bit display Out-of-range -1,1 display Voltage Complies with MIL-STD-2000 measurement Rated power size 200(W)×50(H)×120(D)mm weight approximately1.1kg Usage 0-40℃/32-104℉ 0-80RH% environment 四、Usage: 三、Technical indicators: ①Get ready name Temperature tester 0-600℃/32-1200℉ temperature Scope of the test voltage 0-90mV(AC) 0-90Ω...
Page 5
Press the sliding key in the direction indicated by the arrow and install the sensor (red-ended connection marker There are red dot terminals, blue ends connecting blue dot terminals)。 2. Plug in the power supply and turn on the power switch。 ②Test the temperature of the tip Turn the °F/°C transfer switch to the appropriate position.