Advertisement
2.
Using a Philips screwdriver, remove
the 7 screws on the lamp unit cover
located on the rear of the projector.
3.
Remove the lamp unit cover.
4.
Use a Phillips screwdriver to loosen
each of the two lamp unit fixing screws
until the screws turn freely.
Then hold the handle of the lamp unit
and gently pull it out from the projector.
Caution
The lamp unit will be hot after it has been used.
You might get burned if you touch it while it is still hot.
5.
Install the new lamp unit.
6.
Use a Phillips screwdriver to securely tighten the two lamp unit fixing screws for
each lamp unit.
7.
Install the lamp unit cover, and then use
a Phillips screwdriver to securely
tighten the lamp unit cover fixing 7
screws.
Caution
• Firmly install the lamp unit and lamp unit cover.
If not installed firmly, a protection circuit will
function and the power will not be turned on.
8.
Insert the power cord plug into the wall outlet and then press the MAIN POWER switch.
Caution
• If the power does not turn on (power indicator lamp (red) does not turn on) even after turning the MAIN
POWER switch " ", turn the MAIN POWER "
correctly, and turn on again.
9.
Press the " " button so that a picture is projected onto the screen.
", confirm that the lamp unit and door are installed
3
3
Advertisement
