Page 3
5. Install both HL2024 Connects - in their extended installation position: both parts turned apart until stop - onto the S-connections and up to the rosette by hand. The flow arrow on the HL2024 Connect indicates the flow direction. Hand-tighten the inner sleeve. For a good seal, the inner sleeve must now protrude 0.5 mm further than the measured depth from step 3.
Page 5
Disclaimer: HGP International aim to provide correct and up to date information at all times. HGP International, or companies be- longing to its group, are not liable for possible consequences of any incorrect information provided in this document by mistake. HGP International reserve the right to make changes.
Page 6
Liability is always limited to the amount insured or paid by HGP International. In the event of loss that is not or only partially covered, HGP International's liability is always limited to the invoice amount of the specific delivery or partial delivery.
Need help?
Do you have a question about the HL2024 Connect and is the answer not in the manual?
Questions and answers