INTERTECHNO ITDL-1000 - Radio-Controlled Disconnect Switch Manual

Overview

The radio - controlled disconnect switch is equipped with 2 relays used to switch the p hase conductor and the neutral conductor.
In the first place, the disconnect switch serves to make a room where people stay for a longer period of time free from elec tro smog as far as this is possible.
This applies to bedrooms or children's rooms in particular.
It can also be installed in the fuse box.
Then the light in the relevant rooms is switched ON/OFF by means of the ITDL - 1000.

It is connected up to the power supply line as shown in Figure 1, which has to be carried out by a chartered electrician.

Coding

1. Switch off the main safety device.
2. Connect up the receiver.
3. Switch on the safety device. Have the relevant IT transmitter ready.
4. Briefly press the LEARN BUTTON (L) on the receiver (1 sec.).
   The LED flashes.
5. Immediately press the relevant "ON" button on the transmitter. Then the receiver switches twice to indicate that the code has been accepted.

FINISHED!!

A total of 6 different codes can be stored.
This makes it very suitable for group switching as well.
Several radio - controlled receivers can be switched individually or simultaneously.
The coding remains stored even after a power failure or after dismantling.

Delete individual codes

Proceed as described in 4.) a nd 5.), but press the "OFF" button instead of the "ON" button.

Delete all codes

Press the learn button (L) for approx.6 sec. The LED starts flashing.
Then briefly press the learn button (L) once again.
Then all codes are deleted.
No transmitters are necessary for doing this.

All radio - controlled transmitters from intertechno can be used for switching.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download INTERTECHNO ITDL-1000 - Radio-Controlled Disconnect Switch Manual