Gorgy Timing 92261/XX - IP Sensor Quick Start Guide

IMPORTANT SAFETY INSTRUCTIONS

The device must not be used in particular if:

• It is visible damaged
• It does not work properly
• There are loose parts inside the device
• It was exposed to long term humidity or got wet.

Read the section that follows very carefully before installing your equipment. It gives the safety instructions to follow during installation.
The electrical installation to which the equipment is connected must comply with the NF C 15-100 standard.

In Europe: to comply with European regulations on the protection of persons and the environment, you must dispose of this equipment in a collection site provided for this purpose (separately from household waste). Contact your reseller, collection site or the competent lcoal authorities for more information.
Modifying or opening the product without the consent of the Customer service department will void the warranty.
All maintenance operation shall be conducted with power shut off, including systems connected on relay outputs if any.
Generally, the power cable (220V) and transmission cable (of time signal) shall not be very close to each other, so as to avoid interference (keep the distance of a few centimeters).
Gorgy Timing disclaims all responsibility in case of accident or damage caused by an improper use of the product.

STEP 1: Connecting the cables

• Connect the IP Sensor to the Ethernet network (by straight cable to the Switch, crossover cable to the PC).
• Connect the supply adapter to the mains and connect it to the IP Sensor power supply port.
• The green LED will light up in the RJ45 port.
• If the Ethernet connection is working properly, the LINK (yellow) LED should light up a little while later and switch off during data transfer to the Ethernet (Activity signalling).
• The yellow LINK LED signals communication with the DHCP server by flashing rapidly

STEP 2: Configure the device's network parameters

• IP address / HTTP Port (80 as standard).
• Your network's mask.
• Your network's Gateway IP address.
• The name of the device (optional).

STEP 4: Description of ports

• Ethernet – Used to plug in a cable for an Ethernet Internet connection for operation in a classic computer network and to configure a Wi-Fi connection. This is a PoE (Power over Ethernet) port for taking power from a computer network.
• Temp/Humidity – Used to plug in temperature or humidity sensors. The sensor cable length may be up to 60 meters for each port.
• Power – A port for connecting a 5V power supply if powered by an external adapter.
• Digital inputs - Used to connect sensors with a dry contact (relay) output.

Indicator lights on the front panel

• Link – A green LED signalling connectivity to a computer network.
• Activity – A yellow LED signalling communication in progress through a cable connection to a computer network when flashing.
• Alarm LED – Two LEDs hidden in Port1 and Port2. These LEDs signal Alarm status when on.
• Alarm SENS – Signals Alarm status on one of the temperature or humidity sensors when on.
• Alarm DI – Signals Alarm status on one of the digital inputs when on.
• Reset button - Resets the device to the default settings

support@gorgy-timing.fr

GORGY TIMING SAS
Quartier Beauregard
38350 La Mure d'Isère (Grenoble France)
Phone: +33 4 76 30 48 20
Fax: +33 4 76 30 85 33
email: gorgy@gorgy-timing.fr - www.gorgy-timing.com

RADIO TIMING^®, LEDI^®, LEDICA^®, HANDI^® are trademarks by GORGY TIMING.
Gorgy Timing RC74B38 - Any technical, aesthetic, color modifications can be made without notice.