Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Wi-Tek WI-IOT110
- Page 1 Installation Guide Industrial M2M LTE Gateway WI-IOT110 www.witek-iiot.com...
-
Page 2: Package Contents
1. Package Contents RS232 LAN2 LAN1 RS485 RS232 LAN1 LAN2 GPIO1 GPIO2 RS485 WI-IOT110 1 x AC Power Adapter 1 x 4 PinTerminal 3 x 2 Pin Terminal 2 x WiFi Antennas 2 x 4G Antenna 1 x DIN-rail installation kit... -
Page 3: Hardware Introduction
Two lights are on -95~-105dBm; SINR: 11-14 Serial Port RS-485 RS485 RSSI= one light are on -105~-115dBm; Power Terminal Block SINR: ≤10 WI-IOT110 Attention: DI(0~3V), if the voltage is too high, it may burn out the gateway. Top Panel WiFi WiFi... - Page 4 3. Mounting Mounting the switch on a DIN rail As shown in Figure position the switch so that the spring of the DIN rail mounting bracket compresses against the upper edge of the DIN rail.
-
Page 5: Network Application
Serial Port RS-232 RS232 RS232 WAN/PoE In LAN2/PoE Out LAN2/PoE Out LAN1/PoE Out LAN1/PoE Out LAN1 LAN2 LAN1 LAN2 DI/DO Terminal DI/DO Terminal GPIO1 GPIO2 GPIO1 GPIO2 Serial Port RS-485 Serial Port RS-485 RS485 RS485 Power Terminal Block PoE In WI-IOT110 WI-IOT110... -
Page 6: Login Method
GPIO1 GPIO2 Primary ADSL / Fiber / Cable RS485 WI-IOT110 Please connect devices according to the above topology. Follow the steps for quick Gateway configuration, using initial setup wizard: Step 1 Connect your PC to device via Ethernet or wireless. - Page 7 6. Quickstart Configuration Steps Click Quickstart, General, select Timezone or click Sync with browser, select Internet Mode Priority, WAN Mode and Cloud, and then click Next to enter. Configure WiFi SSID and WiFi Key, and then click Next to enter.
- Page 8 Configure IP Address, Net Mask and DNS, and then click Next to enter. If you need to configure 4G information, you can configure them. If you do not need to directly click Next. Configure WAN Mode, you can configure them. If you do not need to directly click Next.
- Page 9 If you need to configure Azure-Cloud or Amazon-Cloud, you can configure them. If you do not need to directly click Finish. Waiting device reboot.
- Page 10 7. Cloud Management Settings Click Cloud-IoT and Enable Azure. Fill in the Scope ID, Device ID, Device Key and DTMI Select the content you want to upload, and then Click Save & Apply. Here are the steps to get the above information from Microsoft Azure. Step 1 Launch your web browser then enter https://login.microsoftonline.com/ in the address bar.
- Page 11 Step 4 Clink Device templates, Edit DTDL to get dtmi.
-
Page 12: Warranty Card
Warranty Card Username Address Telephone No. Purchase Shop Purchase Address Product Model No. Purchase Time Serial No. Dealer Signature If the product defects within three months after purchase, we will provide you a new product of the same model. If the product defects within the three-year warranty period, we will provide the professional maintenance ser vice.
Need help?
Do you have a question about the WI-IOT110 and is the answer not in the manual?
Questions and answers