Table of Contents
Advertisement
Quick Start Guide
6.3.1 Configuring parameters
For the various sensor types, there are various defined distances between the METPOINT
and the leak that must be maintained in order to be able to calculate valid values for the leakage
loss volumetric flow rate and the costs per year. These distances must be maintained as exactly as
possible without fail; see section 9.4 for more information.
6.3.2 Configuring the measuring point
The parameters need to be entered in order to be able to
calculate the leakage volumetric flow rate.
The following settings must be configured.
-> Sensor type
Select the sensor type based on the application and ambient
conditions in question; see section 9.4.
Home -> Configuration -> Parameter -> Pressure and Distance
You can enter any value you want for the pressure and
distance into the two white fields, provided that the values
fall within the valid range.
You can set the pressure to any value between 1 and 10 bar.
Home -> Configuration -> Meas. Point
The measuring point is stored for each leak in the
corresponding leakage data (XML file). This information can
be viewed later on in the software's leak report.
You can enter the company and building information when
entering the building. Meanwhile, the place refers to the
exact location of the leak and is intended to make it easy to
find again for repairs.
-> LeakTag: Automatically incremented by 1 after every stored
measurement.
METPOINT
CID
®
CID
®
11 | 28
Advertisement
Table of Contents
