Rosenbauer LCS 2.0 Operation Manual

Digiview/digipot with pump pressure governor

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Operation manual

Operation with LCS 2.0

Digiview/Digipot with pump pressure governor

Item number:

Release:

Language:

Abbreviation:

XYZ0815

01/2014

English

LBru

Table of Contents

Need help?

Do you have a question about the LCS 2.0 and is the answer not in the manual?

Questions and answers

Summary of Contents for Rosenbauer LCS 2.0

Page 1 Operation manual Operation with LCS 2.0 Digiview/Digipot with pump pressure governor Item number: XYZ0815 Release: 01/2014 Language: English Abbreviation: LBru...
Page 2: Table Of Contents
Table of contents 1 Legal notice ......... 1.1 Copyright .
Page 3 6.8 Flush/drain ........7 Troubleshooting ........7.1 Warnings .
Page 4: Legal Notice
ORIGINAL OPERATION MANUAL Legal notice Copyright All rights to this manual and their attachment are reserved by Rosenbauer International AG. This document is for the personal use of the recipient only. No part of this document may be reproduced or transmitted in any form or by any means,...
Page 5: Introduction
Rosenbauer is not liable for any injury or damage caused by personnel un- familiar with the operational procedures described in this manual, failing to comply with the operation manual and/or failing to comply with regulations, subsequent procedures, safety and accident prevention.
Page 6: Use Of The Operation Manual
Introduction Use of the operation manual Use of the operation manual 2.3.1 Validation This manual provides information needed to operate the product. This manual contains descriptions of special equipment as well as some abstractions and exemplary illustrations. The actual equipment of the prod- uct may therefore differ in part from the descriptions and illustrations.
Page 7 Introduction Use of the operation manual Warning notices Safety informations alert the user of hazards and inform how to beware of the hazards. Safety informations are written at the beginning of the chapter, before in- structions to perform an action, which assume a hazardous situation. Fur- ther safety informations are located at the beginning of this manual.
Page 8: Safety
The incorrect use of the product (vehicle, portable pump, etc.) may cause personal injury. In addition the product or other property may be damaged. Rosenbauer can only guarantee safety, reliability and performance of the product, if it is used as described in this manual.
Page 9: Training And Qualifications
Modification and changes at the product, fire fighting superstructure and built-in equipment maybe carried out only with written permission of Rosenbauer and by the manufacturers authorised person. - 9 -...
Page 10: General Safety Instructions
Pay attention to the operation and service manual from additional products and of the chassis manufacturer. If faults cannot be solved or if repairs cannot be carried out by special trained personnel, immediately contact Rosenbauer International AG or your nearest Rosenbauer representative. - 10 -...
Page 11: List Of Conventional Signs
Safety List of conventional signs List of conventional signs 3.6.1 Warning Signs This warning sign indicates danger of electric shock hazard. This warning sign indicates fire hazards. This warning sign indicates explosion hazards. This warning sign indicates danger of oxidizing materials. This warning sign indicates danger of harmful or irritant materials.
Page 12 Safety List of conventional signs This warning sign indicates danger of high pressure. This warning sign indicates danger of high vacuum. This warning sign indicates danger of overhead loads. This warning sign indicates a hazardous to environment. This warning sign indicates a risk of falling. This warning sign indicates danger of shearing.
Page 13: Prohibition Signs
Safety List of conventional signs 3.6.2 Prohibition Signs Do not smoke! Do not handle with open flames! Do not step here! No climbing for unauthorized personnel! Do not extinguish with water! Do not spray water! Do not linger under the rescue platform! Do not touch or grip inside! Do not linger in the danger zone! No access for unauthorized personnel!
Page 14: Mandatory Safety Signs
Safety List of conventional signs 3.6.3 Mandatory Safety Signs Wear ear protections. Wear goggles or protective face shield. Wear goggles and ear protections. Wear safety helmet. Wear safety gloves. Wear safety boots. Wear full body protection. Wear seat belts. Wear self contained breathing apparatus. Hold handrail.
Page 15 Safety List of conventional signs Take care of environmental protection. - 15 -...
Page 16: Warning Notes
Safety Warning notes Warning notes DANGER! Danger of fatal or severe injury to the crew or pedestrians due to moving the vehicle or its components during service operations/ maintenance and repair work. Prior to service and repair works: Stop the engine with parking brake applied. ...
Page 17 Safety Warning notes WARNING! Danger of injury and accidents! Danger of injury and accidents due to malfunctioning or improper used safety devices! Do not override safety and protective devices.  Do not manipulate or render safety and protective devices.  Check safety and protective devices for proper function.
Page 18 Safety Warning notes Danger of falling! Lingering on the roof during fire-fighting operations or vehicle movement could result in death or serious injury. Do not linger in the danger zone.  Lingering on the roof is permitted only for manually operation of the ...
Page 19 Safety Warning notes Danger of fatal or severe injury due to rolling over of the vehicle. Almost all fire fighting vehicles have systematical high points of gravity; additionally, they are typically loaded to a point just below their permissible total weight. Incorrect driving (even in emergency response situations) can lead to rolling over of the vehicle.
Page 20 Safety Warning notes Danger of serious injury and damage due to explosion, fire and chemical burns! When charging vehicle batteries, a highly explosive electrolytic gas mixture (hydrogen and oxygen) is released; it is easily flammable and may release highly acidic battery acid. Wear safety goggles whenever servicing a battery.
Page 21 Safety Warning notes Danger of fatal or severe injury due to falling down from an exposed location! Use safety/protection equipment.  Be careful when climbing up or down the ladder.  Use the ladder rungs and hand rails as intended. ...
Page 22 Safety Warning notes Safety clearance with portable fire extinguisher, when extinguishing at low-voltage installations Voltage Kind of extinguishing Safety clearance up to 1 kV Dry chemical powder (ABC, BC), CO2 and halon 1 m (3 ft) Water fire extinguisher, wall hydrant 3 m (9 ft) Safety clearance with C-nozzle and high pressure nozzle, when extinguishing at low voltage installations...
Page 23 Safety Warning notes CAUTION! Danger of injury for the operator due to performing action in wrong order! Individual operating instructions must be done in the prescribed order.  Danger of hearing damage due to extended presence in the vicinity of the running pump! Use hearing protection.
Page 24 Safety Warning notes Danger of injury due to burns! A short circuit releases powerful currents that can considerably heat up and even melt metals. Use only jump start cables in line with ISO 6722 and NATO connector.  In case of jump start cables with crocodile clips, ensure correct polarity. ...
Page 25 Safety Warning notes Danger to health due to extinguishing agents! The contamination with extinguishing agents can cause health problems. Observe wind direction, to avoid a inhalation or contamination by  extinguishing agent. Wear protective gear.  Wear safety goggles.  Avoid direct contact with extinguishing agent.
Page 26 Safety Warning notes Danger of crushing! Danger of crushing due to pneumatic cylinders and drives. Do not grasp moving parts.  Do not reach into the danger zone.  - 26 -...
Page 27 Safety Warning notes NOTICE Damage due to cavitation! The pump capacity is reduced with increasing suction height. When operating with great suction heights, high pump speeds and very high discharge rates, the pump may cavitate. Cavitation causes extreme pressure and temperature peaks which can destroy the pump. Cavitation may sound like marbles are being pumped through the system.
Page 28 Safety Warning notes Damage to electronic assemblies due to actuating the battery main switch! The battery is an important part of the vehicle’s electrical circuit even when the engine is running. If the vehicle power supply is interrupted at the battery main switch while the engine is running, power peaks can occur, this can destroy the electronic equipment of the chassis and superstructure.
Page 29: Product Description
Product description Digiview Product description Digiview Digiview display The Digiview display gives the operator essential status informations of the vehicle system. Three function switches are placed under the display. With the left and right function switch, the screen page can be scrolled forward or backward. With the function switch in the middle, warnings can be verified.
Page 30: Technical Description
Technical description Digiview Technical description Digiview 5.1.1 Main display All important basic informations about the pump pressure governor are shown in the main display of the Digiview. The pump pressure is shown and simultaneously a graphic shows the actual pump pressure and the adjusted pump pressure.
Page 31: Vehicle Data Overview
Technical description Digiview • Pump pressure governor is deactivated. Engine speed The engine speed gauge shows the speed of the engine. The engine speed is shown in the adjacent text field. 5.1.2 Vehicle data overview Important vehicle data are shown in the display of the Digiview. When crossing a limit a warning and a boundary line in the graphic and as well an audible warning are activated.
Page 32 Technical description Digiview Operating hours overview - 32 -...
Page 33: Function Switches In The Pump Compartment
Technical description Function switches in the pump compartment Function switches in the pump compartment Icon Code Name Function description The switch turns the water pump on. The switch has two switching positions: Pump station start • Activated: Status LED active •...
Page 34: Operation
Operation Preparation for startup Operation Preparation for startup CAUTION! Danger of injury to persons or damage to the vehicle due to failure to perform a visual check! Perform the visual checks before driving to make sure that: Roof turret is in transport position. ...
Page 35: Monitoring During Operation
Operation Monitoring during operation After switching off the ignition, the deactivation of the electric power supply is initiated temporally delayed. The temporally delay can be extended up to 5 min, while all electronic systems power down. For further information, please refer to the chassis manufacturers manual. For electric power supply, keep the engine running during all operations.
Page 36: Operation On The Pump Control Panel
Operation Operation on the pump control panel Operation on the pump control panel 6.4.1 Pump operation WARNING! Serious injury to persons and material damage due to overload of the pump system! Excessive temperature or incorrect pump pressure will lead to serious injury to persons and material damage along with increased wear on the pump.
Page 37: Engage And Disengage The Pump
Operation Operation on the pump control panel 6.4.2 Engage and disengage the pump Engage pump ► Stop the vehicle. ► Shift gear into neutral. ► Apply parking brake. ► Let engine idle. ► Actuate function switch Pump station start . The pump engagement procedure is done as following: ...
Page 38: Adjust Pump Pressure
Operation Operation on the pump control panel 6.4.3 Adjust pump pressure The pump pressure will be varied with the pump pressure governor. Pump pressure governor ► Turn pump pressure governor clockwise, to increase the pump pres- sure, until the desired value is shown on the display. ►...
Page 39: Tank Suction Operation
Operation Tank suction operation ► Actuate caps lock key in the middle of the pump pressure governor, to activate the automatic pump pressure governor. The pump pressure governor illuminates blue and the adjusted pump  pressure is built up. The pilot lamp Pressure governor is active. ...
Page 40 Operation Flush/drain For detailed description of the individual operating steps and relevant safety information, please refer to the separate manufacturers operating manual. - 40 -...
Page 41: Troubleshooting
Troubleshooting Warnings Troubleshooting Warnings 7.1.1 Digiview Warning windows are shown in the display and have to be confirmed by the operator by pressing the middle function switch to turn of the audible signal and hide the optical view. After conforming the warning the display changes to the main display. On the left side of the display the symbols of the shown warnings are shown and extinguish after the cause of the warning has been remedied.
Page 42 Troubleshooting Warnings If the engine temperature is too hot, a warning window appears in the dis- play. If an engine fault occurs, a warning appears. If a general fault occurs, a warning appears. If the tank content falls below a certain limit a warning appears. Warning extinguishes if the water tank content rises over a certain limit.
Page 43 Troubleshooting Warnings If a voltage error occurs (e.g. battery voltage too low) a warning appears. If a pump fault occurs, a warning appears. If the pump temperature is too hot, a warning appears. - 43 -...
Page 44: List Of Abbreviations
List of abbreviations List of abbreviations Fire fighting specific abbreviations Power take off Normal pressure High pressure AFFF Aqueous film forming foam Piston priming pump, priming pump Aluminium technology O-stream nozzle Portable pump UHPS Ultra high pressure system Plastics and drinking water DVGW German Association of Gas &...
Page 45 List of abbreviations General abbreviations lbs/s Pounds per second Feet Gallons per minute - 45 -...