Page 2
Remove the batteries from the measuring tool when not using it for extended Spirit Level for Horizontal Alignment periods. When storing for extended periods, the batteries can corrode and self- discharge. Laser Outlet Opening for Line Operation Laser Outlet Opening for Point Operation Operation Supporting Points...
Page 3
(5) must face upward and the aluminium supporting surface WARNING: Do not point the laser beam at persons or animals and do not look into (2) of the measuring tool must face sideward.
Page 4
For marking out, always use the centre of the laser point or the laser line. solvents. Regularly clean the surfaces at the exit opening of the laser in The size of the laser point as well as the width of the laser line will change particular, and pay attention to any fluff of fibres.
Page 5
Our products are designed to be used correctly and with care for the purpose for which they are intended. No liability is accepted by the Tool Connection for incorrect use of any of our products, and the Tool Connection cannot be held responsible for any damage to personnel, property or equipment when using the tools.