Advertisement
Quick Links
Advertisement
Summary of Contents for TBI PRO Engineering RaLights GL-21
- Page 1 RaLights GL-21 L A N D S C A P E S O L A R L I G H T S U S E R M A N U A L...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Introduction Package contents Specifications Solar Light Location Operation Guide Installation Warranty limitations... -
Page 4: Introduction
INTRODUCTION Thank you for your purchase. 21 LEDs spotlight solar charged lights are brighter and last all night with a standard solar charge. Unique design, superior light output, and numerous installation options confirm the outstanding value of our product. The unique optical controlled technology ensures that the light is auto charging in the daytime and automatically lights up at night. -
Page 5: Specifications
SPECIFICATIONS LEDs 20 Leds+1bulb Lighting Area up to 200 sq ft Lighting Color Cold Adjustable angle of Solar up to 180° Panel Adjustable angle of Light up to 90° Head Modes 3 Light modes (High, Medium, Low) Battery 2200 mAh type 18650, 3.7V Solar panel 5.5V, 1.54W Lumen... - Page 6 WARNINGS AND SAFETY INSTRUCTIONS Do not allow children to install or operate the light. Do not install the light in poor weather conditions, especially when lightning is present. Ensure the area where the light is being installed is free from obstructions such as underground wiring, rocks and sprinklers.
-
Page 7: Solar Light Location
SOLAR LIGHT LOCATION IN THE GROUND Place the solar landscape light in a position where sunlight will reflect on the solar panel free from cover and shade. ON THE WALL Ensure that the solar panel will not be affected by any light source, otherwise the light will not illuminate at dusk. -
Page 8: Operation Guide
OPERATION GUIDE Charge it under direct sunlight for 8 hours before its first use. Make sure the product has enough power. The default mode of the product is OFF mode. Press the Power button on the back side of the Solar Panel to adjust modes when using the product. - Page 9 HIGH LIGHT MODE Working Duration: Press the Power 10-12 hours button once. After fully charging the battery. MEDIUM LIGHT MODE From the High Light Working Duration: 14-15 hours Mode setting, press the After fully charging the battery. power button again. The brightness will decrease in comparison to the high light mode.
- Page 10 LOW LIGHT MODE From the medium light Working Duration: 15-20 hours mode setting, press the After fully charging the battery. power button again. The brightness will decrease in comparison to the medium light mode. OFF LIGHT MODE From the low light The landscape light will mode setting, press the power OFF.
- Page 11 NOTE It is recommended to turn OFF the light and charge it under direct sunlight for 8 hours before its first use. Make sure the product has enough power. To check if the product is functioning properly in the daytime, please turn it on by pressing the back button and then cover the solar panel with your...
- Page 12 remember to clean it regularly. The RaLights Solar landscape Lights are waterproof, heat-resistant, frost resistant, suitable for any weather condition, and suitable for outdoor patio, garden, lawns, decks, yards, drive, outside wall, fence, etc. On the RaLights solar panel there is a photosensitive control switch.
-
Page 13: Installation
INSTALLATION IN THE GROUND WARNING Ensure the area where the light is being installed is free from obstructions such as underground wiring, rocks and sprinklers. Ensure that the location where the light will be installed allows for adequate sunlight throughout the day to charge the battery sufficiently. - Page 14 STEP 2 You can change the height using the extension pipes to help you choose the optimal spotlight height. To do this, insert one pipe into the other, then insert a ground stack and place a spotlight on the top. The maximum height with two extension pipes is 48 cm.
- Page 15 STEP 5 Adjust the angle of the solar panel and the light by loosening the knobs on the side of the light. Do not remove the bolt / knob completely. Only loosen to allow for adjustments. STEP 6 Once the light and the panel are at the desired angle, tighten the knob to lock into place.
- Page 16 ON THE WALL WARNING Ensure the area where the light is being attached is free from wires, plumbing or other obstructions. If using a ladder, ensure the footing is secure before climbing and obtain assistance when needed. Ensure that the location where the light will be installed allows for adequate sunlight throughout the day to charge the battery sufficiently.
- Page 17 STEP 1 Hold the light in position and ensure the light is level. Mark the hole positions and again check to ensure the light is level. STEP 2 Predrill the marked location of the holes. Prior to drilling, ensure the area where the light is being attached is free from wires, plumbing or other obstructions.
-
Page 18: Warranty Limitations
PRODUCT WARRANTY We provide our RaLights products with a 12 month limited warranty from the date of purchase. To make a warranty claim, please feel free to first contact our support: support@tbi-pro.com +1 800 674 92 29 (Mon-Fri 8:00-20:00 GMT-6) WARRANTY LIMITATIONS The following are not covered by our warranty: Purchases from non-authorized sellers or distributors. - Page 19 Questions? Contact us at support@tbi-pro.com +1 800 674 92 29 (Mon-Fri 8:00-20:00 GMT-6) www.TBI-STORE.com...