Table of Contents
Advertisement
lenses clear – at least as clear as they get - 100% of the time). in the presence of
an iR sync signal, the lenses will alternate between the opaque and clear state in
synchronization with the iR signal. They will alternate too quickly to have the fl icker
perceived, but the effective transmission will drop by 50%. This is detectable by the
viewer, but not objectionable so it is a suitable test condition just before the movie is
started even in the presence of an audience, if needed. if iR is present, placing your
hand over the iR detection window will cause the lenses to go to a bright clear state.
Removing your hand from the iR detection window will cause the lenses to darken.
This is a confi rmation that the system is working.
Installation
installation is straightforward. The XPAND – ONe bundle consists of the following
components:
• The ADe1512H
• A cable to be run from the projector to the ADe1512H
• The 24VDC AC adapter for the ADe1512H
• Cable to be run from the power brick to the ADe1512H
• AT100 tester
• Hardware for mounting the ADe1512H
© XPAND, All Rights Reserved.
5
www.xpandvision.com
Advertisement
Table of Contents
Need help?
Do you have a question about the ONE ADE1512H and is the answer not in the manual?