Summary of Contents for SAGRA DCD-150
- Page 1 DCD-150 Instruction Manual NEVER TURN ON MACHINE WITH HARDENED OR THICK PRODUCT INSIDE.
- Page 2 Do not operate the machine if you observe any damage. If the machine has any damage whatsoever, it must be returned to Sagra Inc. for examination or repair immediately. When the bowl is removed, the base can be extremely hot. Avoid any contact with the top of the base as the heating element is located directly beneath and you could be burnt.
- Page 3 PARTS Dimensions Width: 10.25” Depth: 12.5” Height: 19.5” Capacity 5 Quart / 6 Liter Electrical Specs 110v 60Hz 1200W 11 Amps -Faucet Handle -Faucet Piston -Faucet Pin Page 2...
-
Page 4: Operating Procedures
OPERATING PROCEDURES IT IS NECESSARY TO READ THIS INSTRUCTION MANUAL CAREFULLY TO KNOW THE SPECIFICATIONS OF THE DISPENSER. AS ALL MECHANICAL PRODUCTS, THIS UNIT REQUIRES CLEANING AND MAINTENANCE. ITS WORKING ORDER CAN BE COMPROMISED BY POSSIBLE ERRORS MADE BY THE OPERATOR DURING DISASSEMBLY AND CLEANING. FOR THIS REASON IT IS IMPORTANT THAT THE STAFF IN CHARGE OF THE DISPENSER IS QUALIFIED TO CARRY OUT THE DAY TO DAY OPERATIONS, WHICH ARE DISMANTLING, CLEANING, STERILIZATION AND REASSEMBLY. - Page 5 OPERATING PROCEDURES READY TO USE (cont.): • Prior to use, make sure the dispenser has been completely sanitized. • Fit the paddle, carefully twisting counter clockwise until it is properly seated. The lid will not fit properly until this is on completely. (Shown in picture below) •...
-
Page 6: Cleaning And Sanitizing Procedures
CLEANING AND SANITIZING PROCEDURES Cleaning and sanitizing are essential to maintain perfect taste and maximum efficiency from your dispenser. The procedures described below are general and can vary due to the sanitary regulations of the local health department. DISASSEMBLY- *BEFORE PROCEEDING TO DISASSEMBLE ANY COMPONENT ALWAYS DISCONNECT THE UNIT FROM THE ELECTRICITY REMOVING THE PLUG. -
Page 7: Troubleshooting Tips
DO NOT RUN THE MACHINE WHILE UNATTENDED OR OVERNIGHT. PRODUCT CAN THICKEN AND CAUSE TO OVERHEAT. Try Sagra "Liquid Chocolate" in your DCD-150 for an easy to use product that won't harden. Just pour in and add milk. If looking for a higher end shaved chocolate, try our Cioccolata Calda Italian Style Drinking Chocolate. -
Page 8: Warranty Information
LIMITS OF LIABILITY Sagra, Inc. responsibility under this or any other warranty, implied or express, is limited to the repair replacement or refund of the product purchase, as set forth above. These remedies are the sole and exclusive remedies for any breach of warranty. - Page 9 DCD-150 Fan / Motor Lubrication Due to the strain caused by too thick of chocolate (or running with hard chocolate), DCD-150 motor, gears and fans can incur noise. This generally is due to excessive heat caused by strain on motor removing the lubricant too quickly.
- Page 10 STEP 3: Gently remove the base. Do not disconnect any wires or pull on any wires. Having someone support this while you spray is recommended. STEP 4: Do not spray while running. Spray only DIELECTRIC grease or lubricant into where the blue straw is pointing.