Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fujion FH-GS5520 SVSS
Summary of Contents for Fujion FH-GS5520 SVSS
- Page 1 Built-in Gas Hob...
-
Page 2: Important Safety Precautions And Recommendations
Dear customer, Thank you for selecting this Fujioh product. The safety precautions and recommendations provided in the manual are for your own safety. Please keep this booklet for future reference relating to the operation and maintenance of the gas hobs. This gas hob shall be used for domestic cooking only. - Page 3 2. Warning symbols for toughened glass gas hob Do not place anything e.g. flame tamer asbestos mat, between pan and pan support, as serious damage to the appliance may result. Do not remove the pan support and enclose the burner with a wok stand, as this will concentrate and deflect heat onto the hotplate.
- Page 4 3. Models and parts of the gas Hob FH-GS5520 SVGL FH-GS5530 SVGL FH-GS5520 SVSS FH-GS5530 SVSS Auxiliary Ultra-rapid Gas burners B. Auxiliary A. Ultra-rapid LPG: 5.0 kW / Town gas 4.0 kW LPG: 1.4 kW / Town gas 1.4 kW C.
- Page 5 4. How to use the gas hob Gas burners The gas flow to the burner can be regulated by turning the corresponding control knob to one of the following positions. (see fig.1) OFF (close valve) High (maximum aperture or flow) Low (minimum aperture or flow) The size of flame depends on the position of the related burner control knob Fig.1...
- Page 6 Battery Ignition The automatic ignition system is powered by a 1.5 V battery. If the automatic ignition does not work, check the battery compartment under the gas hob to ensure that the battery is positioned correctly. Replace the battery if necessary (see fig.8).
- Page 7 Correct use of Ultra-rapid burner To use the wok, you need to position the wok directly onto center of the pan support. Recommended wok top open diameter shall not exceed 36 cm. For gas hobs models without Auxiliary and auxiliary burners, when using the flat bottom pan with diameter less than 12 cm, you need to position the mini trivet provided onto the pan support.
-
Page 8: Cleaning And Maintenance
5. Cleaning and maintenance Cleaning and maintenance should be carried out after the appliance has turned cold especially when cleaning burner and the cast iron support. Avoid leaving alkaline or acid substances (lemon juice,vinegar etc.) on the surfaces.Avoid using acid or chlorine-based cleaning products. Caution: Special care should be taken around the underneath of the appliance as this area is not designed or intended to be touched and may contain sharp or rough edges,... -
Page 9: General Advice
After cleaning the burners and the caps must be well dried and put back correctly. It is very important to check that the burner flame distributor F,burner cap A and cap B has been correctly positioned (Fig.6)-failure to do so can cause serious problem. -
Page 10: Installing The Battery
6. Installing the battery Insert a DC1.5V battery into the battery compartment (see below fig.8 ) in the cover. This battery is the power supply for the electronic ignition of gas burners. Notes for battery installation or replacement: . Only use a DC1.5Volt battery (size “D”) . -
Page 11: Installations Instructions
7. Installations instructions IMPORTANT . The appliance should be installed, regulated and adapted to function with other types of gas by a QUALIFIED INSTALLATION TECHNICIAN. Failure to comply with this condition will render the guarantee invalid. . The appliance must be installed in compliance with regulations in force in your country and in observation of the manufacturer’s instructions. - Page 12 Please be ensure to use the correct dimensions as shown below for installation. Cut Out Dimension(mm) Replacement size(mm) Height(mm) Model FH-GS5520 SVGL FA55×RA58 W(650-740)×D(350-430) × R60 W650×D350 FH-GS5520 SVSS FA24×RA84 FH-GS5530 SVGL FA56×RA58 W(705-840)×D(405-480) × R60 W705×D405 FH-GS5530 SVSS FA20×RA85 4-R60...
- Page 13 INSTALLATION OF GAS HOB IN KITCHEN CABINET WITH DOOR The cabinet has to be made in accordance to specific requirements to ensure proper operation of the gas burners when the flame is turned down to minimum, pressure change while opening and closing the cabinet doors. The cabinet should have openings to facilitate ventilation (see Fig.12 &...
-
Page 14: Ventilation Requirement
VENTILATION REQUIREMENT The appliance must be installed in compliance with applicable local regulations concerning ventilation and the evacuation of exhaust gases. Intensive and prolonged use may need additional ventilation, for example, opening of a window or to have a more efficient ventilation. CHOOSING SUITABLE SURROUNDINGS The room where the gas appliance is to be installed must have a natural flow of air so that the gas can burn. -
Page 15: Testing Operation
TESTING OPERATION After the gas pipe connection has been completed, the gas leak test MUST BE performed before the installation is considered completed. After connecting to the mains, check that all the couplings are correctly sealed, using soap solution. NEVER use a naked flame. If bubbles appear, please close the gas valve immediately and re-adjust the gas connection before re-test the appliance. - Page 16 Southeast Asia Regional Headquarters 3014A Ubi Road 1 #06-04 SINGAPORE 408703 Tel: +(65) 6286 3286 Fax: +(65) 6285 3285 E-mail:fit@fujioh. com. sg...
Need help?
Do you have a question about the FH-GS5520 SVSS and is the answer not in the manual?
Questions and answers