Tekvox Podium TCX10 Installation Manual

TCX10 - Podium
78042-10A Installation Guide

Included in this Product Package:

TCX10 Touchscreen
Controller

Step 1: Select Location for TCX10

Step 2: Drill Hole for Cable Pass-Through

If drilling additional holes in furniture is prohibited, skip this step and proceed with
installation, following directions for over-table cable routing. In desired TCX10 location,
lightly sketch a 3 ¾" square for locating the mounting wedge. In the center of this square,
drill a ¾" dia. hole for the TCX10 cable.

Step 3: Attach Mounting Wedge to Surface

DO NOT OVERTIGHTEN SCREWS
Mounting Device Plate
Wedge
TCX10 mounting location should be conveniently &
easily accessible. TCX10 should not be directly in front
of or behind any other equipment. Allow at least 4" on
either side of mounting wedge. Do not mount TCX10
directly over any structural members of the furniture.
If using over-table cable routing:
Route cable through cutout on back of mounting
wedge. Run cable out through rectangular opening in
mounting wedge, with at least 6" of slack.
All Installations
Using the four (4) included #6 wood screws, attach the
mounting wedge to the table in its intended location.
Ensure that screws are snug, but do not overtighten, as
this can cause the threads to tear through the surface
and lose holding power.
www.tekvox.com
#6 Wood
Screws (4)
Security 6-32 Machine
Bracket Screws (4)