Troubleshooting - YAT YT5601-01 Assembly Manual

Problem
Product does not start
Product does not reach full
power
Unsatisfactory result
Excessive vibration or noise Tines are dull/damaged
This product is equipped with the sign for separate collection and sorting of waste electrical
and electronic equipment (WEEE). This means that when this type of product is processed and
dismantled, it must comply with the requirements of European Directive 2012/19/EU, to reduce
the negative impact on the environment. For more information, contact your local or regional
authorities.
Electronic products that have not been separately collected and sorted, may be dangerous for
the environment and human health due to the presence of harmful substances.
TROUBLE SHOOTING
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the product
Extension cord not suitable for
operation with this product
Power source (e.g. generator) has too
low voltage
Air vents are blocked
Tines are dull/damaged
Tines not suitable for ground material Use product only on suitable
Bolts/nuts are loose
53
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with new one
ground
Replace with a new one
Tighten bolts/nuts
EN