Advertisement
4
2
4
4
4
1
2
Pay Attention
1. Assemble the bottom triangle rst, then attach the three uprights to make the top triangle.
It is designed intentionally to assemble the last triangle with di culty in order to make the angle to be tensioned
and not get loose.
2. The screen wil have some wrinkle due to the rolling up, it will recover after a while when you tension the screen
with zip tie.
3. Please don't cut the zip tie as you may re-use it next time.
4. This zip tie can be released again just by pressing the switch.
5. When all the zip ties are xed, you can tighten it gradually to make the screen as at as possible.
6. The metal clip is used to attach the screen on the top bar. You can leave the metal clip on or remove it.
7. There are two pairs of gloves so it is better to have two person to assemble this screen.
8. Don't tighten the screen too much; otherwise, the screen will be torn.
9. If the screen is dirty, you can clean it with a white cloth; the screen is not suitable for machine washing.
10. The screen can be used indoors or outdoors, but it is not waterproof. You cannot display it outside for a long time
as the black edge around it will be damaged by water.
11. Once you done using the Outdoor Projector Screen, use the zip tie to strap the
stand and store it with the screen in the Storage Bag.
3
4
1
1
4
3
1
1
It is a little bit di cult to put the last side together,
it is intentional to make the triangle tight.
2
4
1
2
4
4
1
4
1
2
1
2
Questions? Comments?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
www.PyleUSA.com
Advertisement
