Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Zline LUXURY TRIM KIT
Summary of Contents for Zline LUXURY TRIM KIT
- Page 1 Installation Manual MICROWAVE DRAWER TRIM KIT www.zlinekitchen.com...
- Page 2 ZLINE Kitchen and Bath provides Attainable Luxury, where the kitchen and bath of your dreams is never out of reach. Through our unique designs and unparalleled quality, we’re dedicated to providing you an elevated experience in the heart of your home. With an endless selection of...
- Page 3 ZLINE is fueled by a passion for innovation; A relentless pursuit of bringing the highest end luxury designs and professional features into everyone’s homes. Because we continually strive to improve our products, we may change specifications and designs without prior notice.
-
Page 4: Important Safety Information
IMPORTANT SAFETY INFORMATION NOTE: This trim kit is available for purchase as a separate accessory for ZLINE’s 24” microwave drawer in stainless steel only. The trim kit is only available for the 24” unit; it is not available in black stainless. -
Page 5: Before Installation
BEFORE INSTALLATION TOOLS NEEDED: • Phillips-head screwdriver • Marker • Drill PARTS INCLUDED: PART QUANTITY IMAGE Outer trim (1) Support beam (2) Front bracket (1) Rear bracket (1) Buckle seat (4) Buckle (4) Finishing washers (4) #1 Screw (4) #2 Screw (16) #3 Screw (2) - Page 6 INSTALLATION Lay the support beams flat on the bottom of the cabinet cutout with the open sides facing each other (see Figure 1). Figure 1 To gauge proper width, temporarily place the rear and front brackets onto the support beams so the rear bracket lips slide into rear holes on top of the beams Front bracket and the front screw holes match to the front of the beams (see Figure 2).
- Page 7 INSTALLATION 2. Remove the screws from the front bottom of your microwave. Using two of those screws, secure the front bracket to the bottom of the microwave, ensuring the lip Front bracket of the bracket is extending down and facing you. Next, remove the screws from the back bottom of the microwave and fasten the rear bracket, ensuring the two small lips are extended down and facing back (see Figures 4 and 5).
- Page 8 INSTALLATION 4. Next, slide the outer trim into the cabinet cutout and use a marker or pencil to ① 将安装好卡扣的外观框放在橱柜上作出比对；用记号笔画上安 装位置 mark where the buckles line up. Then, remove the trim and secure the four buckle 卡扣的外观框放在橱柜上作出比对；用记号笔画上安 Place the trim kit which install buckle on the cabinet for ②...
- Page 9 INSTALLATION 5. Using two people, lift the microwave and push it into the cabinet until the two small lips in the rear bracket slide into both holes in the rear of the support beams fastened in Step 1 to the bottom of the cutout (see Figure 10). 6.
- Page 10 INSTALLATION ① Insert the trim kit into the corresponding buckle seat 将 预装好外观框卡进对应卡扣座里 Insert the outer trim kit into the cutout (see Figure 13). Clip each buckle onto its corresponding buckle seat to complete the trim kit installation (see Figure 14). Figure 13 Figure 14 Finish...
- Page 11 2.0.0 www.zlinekitchen.com 1-614-777-5004 contact@zlinekitchen.com...
Need help?
Do you have a question about the LUXURY TRIM KIT and is the answer not in the manual?
Questions and answers