ICEpower® amplification The KA-1100 is based on a Class D amplifier module from ICE power®. These amplifiers are a high efficiency design and therefore generate far less heat than conventional Class AB amplifiers.
(For further details on mode settings, refer to (figure 6, and refer Trigger in, page 6) page 5) When setup is complete, fit the magnetic front panel facia to the KA-1100 (page 2, figure 1). AV receiver/processor SUB1 Trigger Trigger...
KA-1100 amplifier if the amplifier is your processor gain adjustment. single subwoofer output from your receiver cannot be bridged again. As the negative not intended to be used for an extended G.
Turn down level on your receiver/processor Mode 3 limit 700W RMS per channel @ 4Ohms strobing pattern. input to the signal processor of the KA-1100. (eg 6dB) and then turn up level on your Maximum peak current KA-1100 amplifier (eg +6dB). This will...
Page 7
Krix Loudspeakers Pty Ltd 14 Chapman Road Hackham SA 5163 Australia T 61 8 8384 3433 F 61 8 8384 3419 listen@krix.com BRH.O KA1100 01 krix.com Please read these important safety instructions before you plug in this equipment. Please retain these instructions for future reference.