Download Print this page

Excalibur 196 Series Operating Instructions Manual

Slim line bagel and specialty toaster

Advertisement

Quick Links

OPERATING
INSTRUCTIONS
Slim Line Bagel And
Specialty Toaster
Model No. 196 and 296 Series
Toasters
PRODUCT SPECIFICATIONS
Electrical:
Model No.
Volts
196/296
110/120 60
Hz
Watts KW Amps
1500
1.5
12.5
355 East Kehoe Blvd.
Tel: (630) 462-8800
Toll Free: 1-800-PCASTLE

TABLE OF CONTENTS

Installation ...................................................................... 2
Operating .................................................................... 2-3
Adjustments and Cleaning ............................................ 3
Troubleshooting ............................................................. 4
Parts List ..................................................................... 4-7
Wiring Diagram .............................................................. 7
LIMITED WARRANTY
This product is warranted to be free from defects in
material and/or workmanship for a period of two (2)
years from date of original installation, not to ex-
ceed 30 months from date of shipment from our
factory. Any part or component which proves to be
faulty in material and/or workmanship within the
warranty period will be replaced or repaired(at the
option of Prince Castle, Inc.)without cost to the
customer for parts or labor
This warranty is subject to the following exceptions/
conditions:
l
Service must be performed by an authorized
Prince Castle Service Center.
l
Any use of non-genuine Prince Castle spare
parts voids this warranty.
l
This equipment is portable; charges for on
location service (e. g., trip charges, mileage)
are not include in the provisions of this war-
ranty.
l
All labor shall be performed during regular work-
ing hours. Overtime premium will not be covered.
l
Damage caused by carelessness, neglect, and/
or abuse (e.g., using wrong current, dropping,
tampering with or altering electrical components,
or improper cleaning) is not covered by the terms
of this warranty. Equipment damaged in ship-
ment, by fire, flood or an act of God is not
covered.
l
Normal adjustments as outlined in this manual
are not covered under warranty.
l
Carol Stream, IL 60188
Fax: (630) 462-1460
l
PAGE
196-500

Advertisement

loading
Need help?

Need help?

Do you have a question about the 196 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Excalibur 196 Series

  • Page 1: Table Of Contents

    OPERATING INSTRUCTIONS Slim Line Bagel And TABLE OF CONTENTS PAGE Specialty Toaster Installation ..............2 Operating ..............2-3 Model No. 196 and 296 Series Adjustments and Cleaning ..........3 Toasters Troubleshooting ............. 4 Parts List ..............4-7 Wiring Diagram .............. 7 LIMITED WARRANTY This product is warranted to be free from defects in material and/or workmanship for a period of two (2)
  • Page 2: Installation

    4. Place the conveyor housing into the conveyor guide INSTALLATION and lower making sure that all four conveyor slides are inside the conveyor guide. (Figure 3) 1. After removing the toaster from the carton, promptly inspect the unit for signs of damage. If there is Figure 3 damage to the unit: - Notify carrier within 24 hours of receipt.
  • Page 3: Adjustments And Cleaning

    A soft bristle brush can be Factory Setting: used on hard to clean spots. Rinse thoroughly and The 196 Series Toaster thermostat is set at # 7 allow to air dry. The 296 Series Toaster thermostat is set at # 9 5.
  • Page 4: Troubleshooting

    TROUBLE SHOOTING Problem Cause Solution 1. Unit will not heat up. A. No Power. Ensure Power Cord is Connected to Power Rocker Switch Light Off. Proper Receptacle. And the Power Inlet. B. Inoperable Power Cord. Replace Power Cord. C. Loose Connection on Switch. Tighten Power Switch Connections.
  • Page 5 CONVEYOR ASSEMBLY PARTS LIST Item Part Number Descrption 197-393 Right Side Shaft Carrier Assy. 197-395 Left Side Shaft Carrier Assy. 197-391 Right Side Shaft Carrier Adjustment Assy. 197-388 Left Side Shaft Carrier Adjustment Assy. 81-015 Compression Spring 197-94 Conveyor Slide 197-280 Shaft Assy.
  • Page 6 REAR VIEW PARTS LIST Item Part Num ber Description 197-176 Small Gear 24 Teeth (196, 296, And 196-JACK) 196-9 Small Gear 28 Teeth (196-SP) 197-177 Large Gear 36 Teeth (196,and 296) 196-10 Large Gear 48 Teeth (196-SP and 196-JACK) 197-279 76-225 Slotted Pan Head Screw 197-131...
  • Page 7: Wiring Diagram

    INTERNAL COMPONENTS PARTS LIST Item Part Number Description 76-300 Slotted Pan Head Screw 197-83 Motor (120 Volt) 87-029S 73-031 Hex Nut 79-033 Washer 76-051 Slotted Binder Head Screw 79-055 Flat Washer 76-040 Slotted Binder Head Screw 79-017 Split Lock Washer 73-030 Hex Nut 76-150...

This manual is also suitable for:

296 series