Table of Contents
Advertisement
h. Gas Installation
i. Hose Installation
ZARA GAS COOKER USER MANUAL
Attention
i. All gas connections should be made by a qualified person.
ii. Before installation, make sure that the local distribution conditions (nature of
the gas and gas pressure) and the adjustment of the appliance are compatible.
iii. Make sure that there is air circulation around the appliance.
iv.
The information about the gas supply is on the rating plate.
v. This appliance is not connected to a device, which evacuates the products of
combustion. Make sure to connect the appliance according to current
installation regulations. Pay attention to requirements regarding adequate
ventilation
Connection
i. This range was designed for use with LPG gas
ii. Always use a pressure regulator exclusive for your gas range.
vi. The lack of pressure regulator might cause excess of pressure and leak of gas.
vii. Always check for the validity of the pressure regulator.
viii. Hose and regulator should be replaced every 5 years. Technical specification of
the pressure regulator.
ix. Pressure: LPG 27.5mbar
x. Max. consumption: 2kg/h
xi. Always use a PVC hose to work from-20OC to 100OC. Be sure that hose:
does not have joints.
a. does not go on the back of the gas range neither close to the hot air
exits.
b. Its less then 125cm long.
xii. If possible, install the gas cylinder outside the kitchen, in a place protected and
with air flow.
xiii.
Use a ½ metallic hose to connect to the gas range.
xiv. Only use a plastic hose when this one does not go on the back of the gas range.
i. Place the metal clamp on the hose end.
ii.
Connect the hose to the oven inlet and tighten the clamp.
iii.
Place the other clamp on the opposite hose end and connect it to the pressure
regulator, Tighten the clamp. Bolt the pressure regulator to the gas cylinder
carefully.
iv. After the installation, check if there is any gas leak, using soap or liquid
detergent foam.
v. In order to combat chain first blow a hole in the wall. Put the plastic cap on it
and screw the chain end.
vi. Always check for the validity of the pressure regulator.
vii. Hose and regulator should be replaced every 5 years or when it is broken.
P a g e
6 | 13
Advertisement
Table of Contents
