Summary of Contents for Heybrook TT2
- Page 1 HEYBROOK TT2 INSTRUCTIONS & CONSTRUCTION NOTES Thank you for purchasing the Heybrook TT2 turntable. Please read the following instructions carefully to ensure that your turntable will give you years of exceptional performance.
- Page 2 Place a spirit level on the top surface of the plinth to the left of the platter, and adjust the feet until the plinth is level and does not rock. If the TT2 is moved to a new position repeat the levelling procedure.
- Page 4 The TT2 should always be earthed to your mains supply earth, either through the mains plug or via your amplifier through the pick-up arm earth lead. If a loud hum is noticed when turning up the volume of your amplifier it may result from the earth loop caused by "double earthing"...
-
Page 5: Construction Notes
DISCONNECT FROM THE MAINS SUPPLY BEFORE REMOVING THE BASE PLATE The TT2 is available fitted with arm boards pre-cut for most popular arms. If you wish to cut your own. arm board for a specific application, blank boards are available from your retailer. When a pick-up arm is mounted on the arm board, the arm must be securely fastened to the board. - Page 7 2.3 continued Centre the subchassis in the plinth and remove the spring nut, lower spring seat and spring. Check that the upper spring seat is correctly located in the upper part of the subchassis before reinserting the spring in its correct alignment and compressing it to fit the lower spring seat and nut.
-
Page 9: Faults And Remedies
FAULTS AND REMEDIES FAULT POSSIBLE CAUSE Remedy 3.1 Platter does not revolve 1) Power is not connected – red neon on 1) Check voltage adjustment and mains connections switch should glow. and plug fuse. 2) Remove outer platter, check 2) Replace belt on pulley and replace outer platter. position of belt.
Need help?
Do you have a question about the TT2 and is the answer not in the manual?
Questions and answers