Advertisement
Thank you for choosing the GLOCKENKLANG
Blue Bird amplifier. You have purchased an
exquisite piece of equipment, which was
designed after the most modern technical
aspects.
For your safety
Please read the following instructions
carefully. These tips will ensure long and
trouble free operation of your new
GLOCKENKLANG product.
Operational restrictions
Do not operate the amplifier under the
following conditions:
" In direct sunlight
" In extremely dirty or dusty places
" In extremely humid or wet places
" Around heat emitting appliances
Caution: When rack mounting the amplifier,
make sure to leave adequate room for
ventilation. The unit needs this ventilation
space to adequately exhaust it´s internally
generated heat.
Handling
Do not drop the amp. Do not use excessive
force when activating switches and dials.
Caution!
For optimum sound use always the included
high-end mains cable!
Please, keep this User Manual for future
references
WARNING!
DO NOT OPEN!
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
Care
Use a soft, clean and dry cloth only to clean
the amplifier. Do not use aggressive
chemicals to clean the housing. Do not use
compressed air to clean the housing. You
may carefully vacuum the air intake and
exhaust areas from time to time to remove
loose dust accumulation.
General instructions
Your Blue Bird head´s special features:
After powering the amp, it takes about
2 seconds until the blue ON led lights up
and about another 15 seconds until the
speaker out is activated. This is normal.
"Effect Loop" is a parallel loop with
blending control from 0% till 100% on the
front panel and gain control ±5 dB of Effect
Return. Additional, you can use the Effect
Return either as a mixable Line In or as a
stereo MP3 players input.
It is switched post eq/pre volume-control/
pre-DI out.
The power amp is short circuit, high
temperature, overload and DC voltage
protected. In case of high temperature,
overload or DC current, the speakers will turn
off. After cool down or clear faults the
speakers will turn on again.
Caution!
Due to safe ventilation, do not remove the
bumpers on the bottom of the amp!
Please ensure adequate ventilation when
rack mounting the amplifier.
Leave a minimum of 5 mm space below the
amplifier. Make sure that the air
entry/discharge vents at the right and left side
of the housing are unobstructed.
WARNING!
TO REDUCE THE RISC OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
Advertisement
