Advertisement
Quick Links
26 Corner Install Kit
Series 90-99901
OEM Model# CK-26-1
For Use With AURORA Orion 8910-0000N and 8910-0000POnly
OEM Model# SL-26N & P
Owner's Manual
Installation Instructions
Read This Manual in Its Entirety
Install this kit according to this manual
When installing the AURORA ORION 26 using this Corner Install Kit, you
will need to refer to both these instructions and the installation instructions
supplied with the fireplace.
0
Elbow and a 12" straight section of Direct Vent Pipe will be required to complete the corner
NOTE: A 45
installation.
Rev. 12-13-16
Advertisement
Related Manuals for HearthStone AURORA 90-99901 Series
Summary of Contents for HearthStone AURORA 90-99901 Series
- Page 1 26 Corner Install Kit Series 90-99901 OEM Model# CK-26-1 For Use With AURORA Orion 8910-0000N and 8910-0000POnly OEM Model# SL-26N & P Owner’s Manual Installation Instructions Read This Manual in Its Entirety Install this kit according to this manual When installing the AURORA ORION 26 using this Corner Install Kit, you will need to refer to both these instructions and the installation instructions supplied with the fireplace.
- Page 2 Vent outlet hole and Gas inlet hole. Cut the vent outlet hole and gas inlet hole (refer to the Hearthstone ORION 26 Owner’s Manual). Pre-drill the 9 lag bolt holes with a 5/32” diameter drill. Be sure that there is solid wood at each mounting location. If not, the wall should be reconstructed to provide the needed support.
- Page 3 STEP 3: Attach the wall plate to the wall with the pass through heat-shields in place, and fasten to the wall using the 9 lag bolts provided. Mount the left side first with the 2 outer lag bolts, then mount the right side.
- Page 4 Standard 12” Pipe Length 4” x 6 ” Standard 45 Elbow Vent Starter Pipe (included) Fig.6 STEP 6: Mount the unit on the wall mount and complete the installation as described in the installation instructions supplied with the fireplace. See Fig. 6 & 7. Once the installation is complete, fit the top and bottom corner cover plates to the wall mounting unit using the screws provided.