equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note:
• The Upper Arm Blood Pressure Monitor LK-A2 meets the electromagnetic
compatibility requirements of YY0505, YY0670, IEC60601-1-2;
• Users should install and use the electromagnetic compatibility information
provided by the random files. Portable and mobile RF communication devices
may affect the performance of the Upper Arm Blood Pressure Monitor LK-A2.
Avoiding strong electromagnetic interference when used, such as Close to mobile
phones, microwave ovens, etc.
• The instructions for the guide and the manufacturer are detailed in the
attachment.
Warning:
• Use of this equipment adjacent to or stacked with other equipment should be
avoided because it could result in improper operation. If such use is necessary,
this equipment and the other equipment should be observed to verify that they
are operating normally.
• Use of accessories, transducers and cables other than those specified or provided
by the manufacturer of this the LK-A2 could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and result
in improper operation.
• Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to
any part of the LK-A2, including cables specified by the manufacturer. Otherwise,
degradation of the performance of this equipment could result.
Attachment:
Guidance and manufacturer´s declaration – electromagnetic emission – for all
26
Need help?
Do you have a question about the LK-A2 and is the answer not in the manual?
Questions and answers