Table 31: Character/Element; Table 32: Radio-Beacon Command Message - NorthStar 8700 Technical Reference Manual

05/01/97 REV H
Data field Contents
Element. NVM element to erase as shown below in
xx
Table 31.

Table 31: Character/element

Characters
00
01-04
05
06
07-08
09
10
11
12
13
14
15
Example H:
$PMCAG,007,15*6B<CR><LF>
Erases configuration of the primary port, and CMC binary message list is
transmitted by default after each power-up.
Command message to the radio beacon ($GPMSK)
This message configures the frequency and bitrate parameters of the
radio beacon, and also sets the rate of the output message MSS and
$PMCAG,903 .

Table 32: Radio-beacon command message

Data field Contents
MSK,x.x,a,x.x,a,x.x*hh<CR><LF>
Radio-beacon frequency, 285.5 to 325.0 kHz
x.x
Auto/manual frequency, A/M
a
Section 10 - NMEA protocols
Element
All (Note 1)
Reserved
Almanac
Ionospheric data
Reserved
TCXO parameters
UTC parameters
Position
Time
DGPS configuration
Default NMEA message list
RS-232 configuration (This com-
mand forces the 8700 to go into
binary mode at 9600 baud at next
power-up.)
PAGE 51