Summary of Contents for FClab FC-1000
- Page 1 FCLab USB2 Camera User Manual Page 1 FC-1000/FC-1001 USB2.0 Camera Development Kit User Manual Version 1.1 FClab Incorporation June 12 2004...
-
Page 2: Installation
Installation 1. Package Contents Your product package should include the items listed here. If anything is missing or damaged, please contact the support@fclab.com • FC-1000 /FC-1001 USB 2.0 PC Camera module • Bundled Software Disc • This User’s manual •... - Page 3 No until all selected drivers and applications are installed. After you clicked “ finish” to complete the software installation you may go to the “Program Files” ” FCLAB” folder to check all folders has been installed as following Driver...
- Page 4 Your FCLAB USB2.0 Camera Development KIT has been installed properly Getting start with the FC-1000/FC-1001 Module • For FC-1000 module, make sure you have installed a proper C mount lens and put Focus and Aperture to certain position. • Run “ FCLAB USB2 Camera “ application either from desktop or installed folder.
-
Page 5: Hardware Description
500mA directly through the USB cabling. In FC-1000 design, USB interface not only for image transfer. It also design for a control link Between outside world and computer. During the camera working or idle the USB interface Can work as a USB to RS232, USB to I2C and USB to GPIO. - Page 6 3.3V , 5V @ 300mA power supply FC-1000 USB2 Camera Moudle Hardware Resource Block Diagram The core of FC-1000/FC-1001 is a 48Mhz micro processor with USB2 interface . There are a lot of useful hardware/ firmware resource for customize. These resource including Extra up to 20 bits bit control GPIO interface.
-
Page 7: Mode Selection
FCLab USB2 Camera User Manual Page 7 Application user guide Component Software of FC1000 is composed of two type windows: window for video and window for image. Anytime only one video window for video, but maybe more windows for captured images, snap images, etc. The two windows have different menu and toolbar and functions. -
Page 8: Auto Exposure
FCLab USB2 Camera User Manual Page 8 capture a high sensitive image. The second is De-noise mode, which is suitable for low noise application. The third one is normal mode. From the video window's menu "Mode", you can select one mode of these three. -
Page 9: Capture Image
FCLab USB2 Camera User Manual Page 9 Auto White Balance (AWB) Before you do AWB, please adjust exposure at proper level. Then put an white paper before the lens and choose “video > White Balance” form video's menu. There 's a rectangle on the center image at this operation. -
Page 10: Zoom In / Zoom Out
FCLab USB2 Camera User Manual Page 10 Viewpoint Adjustment You can give an viewpoint when you not in full view(1280*1024). By opening control Panel and the position property page: fig8 viewpoint you can also save these parameters with gain together. The saved will appear on toolbar’s combo box. - Page 11 FCLab USB2 Camera User Manual Page 11 Open and Save in image window’s toolbar to open and save an image.You can open and save files such as jpeg,bmp,tiff,png. Back to Video Window , It’s convenient for you to click this button from image window into video...