Advertisement
Advertisement
Table of Contents
Summary of Contents for GETXENT RASCO
- Page 1 GETXENT RASCO USER GUIDE...
- Page 2 CONTENTS INTRODUCTION PROTOCOL A. Sampling B. Analysis RECOMMENDATIONS...
- Page 3 The Getxent RASCO accessory has been especially designed to optimize the air flow around the Getxent tubes and to be compatible with one of the most performing portable vacuum cleaners on the market. Only few minutes are required to collect the odors for huge volumes. The accessory is made of 316L stainless steel grade, commonly used for medical devices.
- Page 4 PROTOCOL Always wear gloves for each step A. Sampling Open the Getxent RASCO wallet and take the Getxent RASCO accessory out. If necessary, plug the plastic tubing in the push connector. Open the pouch containing non-impregnated Getxent tubes and pick-up a Getxent tube with pliers.
- Page 5 (see the recommandations about sampling duration). When the sampling is done, press the puller on the Getxent RASCO accessory while pulling it until it slides out of the vacuum cleaner. With pliers, remove the impregnated Getxent tube and store it in a clean, small volume, odor-free and tightly closable container.
- Page 6 B. Detection Take the impregnated Getxent tube to be detected from the storage container with pliers. Place it in your detection set-up (line-up, etc.). After the detection, dispose the Getxent tube and the storage container.
- Page 7 Cleaning: Use volatile organic solvent to clean the Getxent RASCO accesso- ry and let it dry. Our best recommendation is to use ethanol 99%. The Getxent RASCO accessory can be washed with tap water to remove dust, mud or any particles then dried.
- Page 8 Any questions ? +41 79 664 59 08 contact@getxent.com www.getxent.com...
Need help?
Do you have a question about the RASCO and is the answer not in the manual?
Questions and answers