Navigating Along Routes - NorthStar 941X Reference Manual

Navigating
Along Routes
starting the
route
"
Rev. D
To follow a route that has been stored in the 941X's memory, press the
WAYPTS/ROUTES key, then the ROUTE LIST menu key. Use the cur-
sor keys to select the route you wish to follow, and then press the GO
menu key. The first four waypoints of the route are displayed.
1 1 1 1
Notice that the arrow shape alternates as you move the cursor up and
down. The first arrow shape designates a single waypoint of the route.
The second designates a leg connecting two waypoints. The two shapes
allow you to start following a route in either of two ways:
1. DIRECT TO WAYPOINT: DIRECT TO WAYPOINT: You may navigate directly from your pre- DIRECT TO WAYPOINT: DIRECT TO WAYPOINT:
sent position to a designated waypoint. To start on a waypoint
other than the first, use the cursor keys to move the pointer to the
desired waypoint, as in screen #1 above. Press the GO menu key,
then ENTER.
2. ALONG A LEG: ALONG A LEG: You may tell the 941X that you want to navigate ALONG A LEG: ALONG A LEG:
along a designated leg of the route. Move the cursor down until it
5 — Waypoint and Route Navigation 5 — Waypoint and Route Navigation 5 — Waypoint and Route Navigation 5 — Waypoint and Route Navigation
2 2 2 2
Page 59