Page 1
User Guide DF15 & DF35 WMTS105:2016 Certificate No. 23291 Freestanding Filtered Water Chiller System Australian Certification Services For correct operation & installation, it is essential to observe these instructions. MAR2022...
Puretec Customer Service Puretec Customer Service Thank you for purchasing a Puretec Freestanding Water Chiller System. Your system is a proven performer manufactured from only quality materials and components and will give years of spring-like water, if maintained properly. The Puretec filter supplied with the Freestanding Water Chiller System needs regular cartridge replacement to maintain optimum performance.
Installation Requirements Fig. 3 - Installation Diagram Drain Port: 40mm DWV Power Cord Water Inlet Installation Requirements The following is a guide but the installer is responsible to comply with any local regulations that may be applicable to this type of installation. Install near a convenient place to connect to a mains pressure water supply of drinking water quality and 220 - 240V/50Hz electrical supply.
Installation Installation Once positioned and levelled remove the front panel Assemble the carafe filler by inserting the gooseneck outlet into the carafe filler base that comes installed on the sink. Ensure the gooseneck outlet is pushed in firmly until properly sealed. An access port for the drain is provided at the rear of the cabinet.
Operation & Maintenance Operation & Maintenance • Frequently clean the fountain using warm soapy water. Avoid all abrasive and corrosive cleaning materials. • Do not pour any waste cleaning water down the drain to avoid blocking the drain trap. • If the chiller is not used (e.g.
Use Guidelines Use Guidelines • Use for mains water supply. • Minimum operating pressure 200 kPa. • Maximum operating pressure 500 kPa. • Do not allow exposure to temperatures below 0 °C, protect from freezing. • Maximum operating temperature 38 °C. •...
Troubleshooting Guide Troubleshooting Guide Fault Possible Cause Suggested Action Check the external power outlet is switched on. Not cooling. The compressor is not running. Check the fuse is in the "on" position. The internal fuse is switched Check the fuse is in the "on" The power is on but not cooling.
Warranty Warranty Notes Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name you can trust for viable and proven water solutions. The complete range of Puretec products are developed, refined, made to meet and exceed stringent specifications for the worldwide market. Important: Sales of products are subject to our Terms and Conditions which are available upon request.
Page 13
Warranty Warranty/Australia This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie Road, Lonsdale SA 5160, telephone no. 1300 140 140 and email at sales@puretec.com.au. This warranty is provided in addition to other rights and remedies you have under law: Our goods come with guarantees which cannot be excluded under the Australian Consumer Law.